Yep I got the eagle alloy 16x8 and the tires r 305/70/16, by going to a 8 inch wide rim I gain a inch of height from my previous wheels that were 10 inch wide.
Yea it's a little tough to want to drill holes in the side of it after all the time I put into the body oh yea and the money, I'm focusing most of my time now on the interior and the suspension.
Finally got to put the new wheels and tires on turned out awesome, makes the truck look angry with some MUDs on her. Thanks for all the advice and u were right about the center caps they look fine.
Hey thanks for the pics I just ordered my rims which will in on Tuesday and tires should be in by the end of the week ill post pics once I have on the truck thanks again
Looking to put some step bars on my k20 for the old lady and I'm looking at the 32 inch stainless dee zee step bar if anyone has dont this and has some pics and how difficult are they to install. Thanks
I'm thinking of putting 16x8 eagle alloy 058 on my k20 with a 305/70/16 BFG km2 and was wondering if anyone has this kind of set up just so I can see how the offset looks my truck also has a 4 inch lift. If anyone has pics would be much appreciated. Thanks
Im thinking of buying a set of bfg km2s they r 305/70/17 and with those i want to buy a set of mickey thompson 17x9 wheels with a 0 offset and a 5 inch backspacing. I know they will fit what im wondering is if the wheels and tires will look good on a 77 k20 with 4inches of lift. I tried the...
Thinking of putting a detroit locker in my 77 k20 it has a corporate 14 bolt diff, was wondering if anyone could give me a link of the best one to get at a reasonable price. thanks
Ok sounds good I have to get a drive shaft made for it also since I swapped trans and transfer case. So ill probably have them take a look at the alignment before I go tearing into it. Thanks again
My 77 chevy k20 dog tracks and its pretty noticable when i drive behind it. I have measured and there is a 1 1/2 difference between the passenger and driverside rear tires. It has a 4 inch suspention lift that was put on by the previous owner. What i need to know is if the pin that lines up the...