Recent content by Layne02

  1. L

    Fuel out the venting

    Working on my 87. Rebuilt Holley performer carb cause it was all gunked up inside. Its got a Carter external pump on it snd Im trying to set the pressure regulator because I cant get it to go above 3psl. Anyway im getting fuel shooting out of the front vent tube, BUT, Im not getting any fuel to...
  2. L

    A/C control , no power

    Well Alright, got it going. Sometimes its the simplest thing. Found brown wire and rechecked making sure to have a good ground with tester and had power, checked everywhere else and had power, theeeen, just happened to notice wire going to blower motor wasnt pushed on all the way . Pushed it on...
  3. L

    A/C control , no power

    Ok, so if thats case should I be getting voltage reading at plug going into back of control head? Im not getting anything. Wiring problems are really hard for me.
  4. L

    A/C control , no power

    So does power gonto the resistor first. What would be the order of checking for power .
  5. L

    A/C control , no power

    Hi everyone, been a while since I worked on the truck , but was just starting it up other day and turned a/c on and absolutely nothing happened. So, I checked the fuse. Seemed to be ok, didn't look blown. So then I took dash bezel and got a/c control out so I could get to wires at back...
  6. L

    Holley fast idle screw

    Ok, I quit fighting with it and unbolted it, picked it up, few turns of 1/4" socket, problem fixed. Easier than trying to wrestle it .
  7. L

    Holley fast idle screw

    No sir its not, wish it was setup different
  8. L

    Holley fast idle screw

    I guess that was my point, its in a hard spot, window to get a wrench on it is extremely small.
  9. L

    Holley fast idle screw

    Got a new Holley Street Warrior carb to replace the old Holley carb that kept being buggy. Runs great but I would like to get the fast idle down a little bit, just seems really high, definitely not the 1400-1600 they say it should be out of the box. Anyway, I know the screw is under the choke...
  10. L

    Lost gauge lights and taillights

    Just getting back to this after working on a blinker problem. So back to the orange and brown wires that plugged into back of original radio. As I said before the harness I got to plug into new radio didnt use the two wires, and if the orange wire controls ctsy lights that may be what is...
  11. L

    Left turn signal problem

    Now if I can just get dash lights working again from another post , I will have electrical stuff done
  12. L

    Left turn signal problem

    Well sometime its the simplest thing. I checked rear ground, it was good. Then I decide to look at front light socket , the inside of it had a lot of gunk in it but it looked like contact areas were clean. I took a small screwdriver and cleaned it out real good and put bulb back and BAM ! ...
  13. L

    Left turn signal problem

    You could be on to something, I didnt check the rear for grounds, why, I dont know. I will check them this afternoon. Thanks
  14. L

    Left turn signal problem

    Turned hazard lights and all work , so dont know what it is. I checked grounds, they are good and tight, but I was curious how many grounds there should be. I have one on each side of radiator bolted to rad core support. Is there a separate ground wire for turn signals? I did do a lot of...
  15. L

    Left turn signal problem

    Its an 87, right side works fine
See more

Latest posts

Forum statistics

Threads
45,570
Posts
986,493
Members
38,662
Latest member
imyourhuckberry
Top