-
-
justhorns reacted to PeteJr's post in the thread What have you done to your square lately?? with
Like.
Finally got the engine/transmission set in today. It's a long process, but I'm somewhat anal about some things........... New radiator... -
justhorns reacted to Snoots's post in the thread What have you done to your square lately?? with Like.
-
justhorns reacted to germando's post in the thread Finally got a squarebody...for my daughter with Like.
No problem guys here are a couple pics for you G
-
justhorns reacted to germando's post in the thread Finally got a squarebody...for my daughter with Like.
Just wanted to say hi from Texas, I just purchased a 1973 sierra grande longbed 454 for my daughter. She is 14 so I have time to get...
-
Just a follow-up, turns out both sending units went bad. Instead of the 0-90 ohms, the senders still vary resistance with float level...
-
I had just bought one some years back before we moved in '18. Lost it, along with all the ball joints and u-joints for my front end...
-
Just rented one from advance auto for $0. They gave me 45 days to return it but only needed it for a couple days.
-
justhorns reacted to Bextreme04's post in the thread Can you tell if a block has 1 or 2 piece rear seal without opening it up??? with Like.
I second the one piece felpro gasket, but be sure you measure FIRST. All one piece rear main engines have the thick front seal(or did...
-
justhorns reacted to Bextreme04's post in the thread Can you tell if a block has 1 or 2 piece rear seal without opening it up??? with Like.
You don't even need to pull anything... the oil pan will look different on the back between one piece and two piece seal. I found these...
-
justhorns reacted to codfish's post in the thread Can you tell if a block has 1 or 2 piece rear seal without opening it up??? with Like.
I’ve read that a pass side dipstick is on a 1 piece block, and a driver side dipstick would indicate a 2 piece rear main seal. This...
-
justhorns reacted to Strick's post in the thread Here's one for the Holley/Eddy debate... with Like.
If I lay heavy on the skinny pedal then I want a Holley. BUT...there's a 750 CFM on both my 72 396 Camaro & my 80 Z28 4 speed. Too easy...
-
justhorns reacted to Octane's post in the thread Here's one for the Holley/Eddy debate... with Like.
A well tuned q jet on a stock or mild sbc works ok in my experience. But much more a Holley is king. Just my experience, and I've...
-
I'd guess that the aftermarket wheel was either installed wrong or the wrong install kit was used, then the tie rods were adjusted to...
-
You could measure your tie rods and see if there the same from side to side. I have a 4x4 so I have a drag link and I will say it...
-
Unless it’s a 6.2 diesel part (because im not familiar with them), my money says it’s not off of a square body. I’ve messed with a lot...
-
-
Loading…
-
Loading…
