Recent content by Gman73

  1. G

    Need some advice please

    Some of the folks on here followed my thread, and many have given me great advice. Thank you all for that. Big question now is what do I do going forward? Long story short I've probably got about 3800 dollars in my ground up restoration thus far on my 73 K 20 and as many know I lost my place to...
  2. G

    really need the experts on this, runs beautiful won't move

    Ok guy's started it with the transfer case in 2 high pushed the clutch in to see if it would get the transmission in gear. no go:mad: the pedal doesn't even have any pressure till about two inches from the floor. I'm guessing it's the throw out bearing. Since I have no place to work on it. I...
  3. G

    really need the experts on this, runs beautiful won't move

    good to know I'll do as suggested and give it another try
  4. G

    really need the experts on this, runs beautiful won't move

    The transfer case isn’t the issue the transmission won’t engage a gear. When I push the clutch in if I try to select any gear it just grinds won’t even come close to going in gear
  5. G

    really need the experts on this, runs beautiful won't move

    talked to an old school guy with a shop around the corner from me, says he's seen it before believes I have the wrong throw out bearing installed. He could be right I just ordered it only looked at one, he says there are three different type bearings, said I should remove the cover plate and...
  6. G

    really need the experts on this, runs beautiful won't move

    Grit Dog, no the clutch doesn't feel right to me, does go through the gears smoothly. All new components from Summit 3 prong pressure plate, new disk, installed with an aligning tool went together smoothly. I had the engine pulled so it wasn't that difficult mating it up. When I dropped the...
  7. G

    really need the experts on this, runs beautiful won't move

    yes transfer case in neutral first thing I checked.
  8. G

    really need the experts on this, runs beautiful won't move

    New issue although the biggest I've faced not sure I can fix it. So with the help of the forum guys I got the truck running and sounds fantastic. Went to put it in gear it's a 4sp with a 205 transfer case and no go, when I push the clutch in I get no response can't move it into any gear just...
  9. G

    What’s the best way to fix this?

    So was cleaning up my fuse panel and two things went wrong. Look at this pic and tell me what you guys think. I pulled out the flasher for the hazards and lost one pin completely the other is sticking out. Also one side of one of the fuse holders broke off.
  10. G

    Where is this under dash?

    Thanks guys that’s what I suspected.
  11. G

    Where is this under dash?

    I’m trying to sort out some wiring issues and have the factor book for my 73 I’m not at my truck currently but wondered where is this located under dash and what’s it’s purpose? Seems like it dead ends multiple connections.
  12. G

    Clutch pedal doesn't return all the way?

    In my rebuild I replaced the pressure plate throw out bearing clutch disk etc, new springs and all the linkage is fine. Works properly, however when I push the clutch pedal in it seems to engage and depress at the right level, but when it comes back up from the floor it doesn't return fully. I...
  13. G

    this is a weird one.... lighting question.

    I have power to all the lights they all come on, only the left taillight blinks
  14. G

    Help me out please starting issue?

    Was firing order got it sorted out thanks
  15. G

    this is a weird one.... lighting question.

    Guys, on my 73 k 20 I've got the dash removed no gauges etc. I do have my fuse block and all my wiring intact. So issue is when I pull my headlight switch out I get headlights all the running lights, brake lights and one turn signal left side rear, no other turn signals. How would I trace this...
See more

Latest posts

Forum statistics

Threads
42,128
Posts
909,770
Members
33,622
Latest member
timk
Top