Gander's latest activity
-
GOnly 1 O2 sensor on the left side manifold, my bad. The ODB1 port is working, I will check for burned bulbs next. I did order a INNOVA...
-
GGander replied to the thread 1987 V10 with 1974 engine- need TBI Help.2 o2 sensors? You sure about that? My 1987 V10 350TBI still had the stock y pipe on it when I got it and there was only 1 o2 sensor...
-
GI agree with the first part, but my experience with the thermostat situation is much different. I have run several TBI engines (4.3l...
-
GGander replied to the thread 1987 V10 with 1974 engine- need TBI Help.Well, all I know is there was a 160 tstat in my truck when I got it and it absolutely wouldn’t go into closed loop that cold. 1987 V10...
-
GGander reacted to vr1967's post in the thread Need a pic of a tank selector valve shield for a 1987 V10. with
Like.
Factory shield off an 87, with upper support rod. -
GGander replied to the thread 1987 V10 with 1974 engine- need TBI Help.Check your throttle body for a vacuum leak at the throttle shaft. The holes in the throttle body itself tend to get wallered out over...
-
GGander reacted to Ricko1966's post in the thread 1987 V10 with 1974 engine- need TBI Help with Like.
195 is not to hot and definitely worth a try. You need to get wiring schematic and find out why your check engine light doesn't work...
-
GGander replied to the thread I've developed a whine in a just 10 miles of driving.You’re leaking trans fluid through the T/Case adapter into the T/Case. Common problem. Simple enough fix, just a bit of a hassle to...
-
GHad a transmission shop rebuild a transfer case for me and install it in my truck. When I picked it up they said they’d noticed on the...
-
GDo a pan drop, filter change, and install a pan with a drain plug. Then do a drain and fill at the next two oil changes or even each...
-
GI would definitely install a drain plug or buy a pan with a plug. Drain and fill your transmission 4 times in the next month,just drain...
-
GDex/Merc would be fine, get an OE filter and a Felpro gasket. If the pan looks distorted in any way get a new one, they are inexpensive...
-
GGander replied to the thread The old Fuel Gauge saga!.Replace the printed circuit on the back of the gauge cluster. I replaced mine when I built a factory tach cluster for my truck. I was...
-
GGander reacted to CalSgt's post in the thread Need a pic of a tank selector valve shield for a 1987 V10. with Like.
I made a heat shield out of a piece of scrap aluminum, a little bend and two bolts through the frame
-
GGander reacted to Mike Gresham's post in the thread What size/length/thread pitch bolts for brace on NP208 transfer case? with Like.
Those bolts are M16-25 and are readily available at your local John Deere tractor store. Remember to use blue LocTite.
