Gander's latest activity
-
GGander reacted to Craig Nedrow's post in the thread What size/length/thread pitch bolts for brace on NP208 transfer case? with
Like.
If you have some calipers, just measure the hole dia, and then compair it to a tap drill chart. Don't have a tap drill chart? get on... -
GGander replied to the thread Need a pic of a tank selector valve shield for a 1987 V10..If you did, that would be awesome. Let me know and anyone got a pic of this mounted on there so I can see how it’s connected?
-
GGander reacted to vr1967's post in the thread Need a pic of a tank selector valve shield for a 1987 V10. with Like.
Let me look, I may have one or two spares.
-
GGander posted the thread Need a pic of a tank selector valve shield for a 1987 V10. in Tech Discussion.The little shield that covers the tank selector valve on my truck is missing, probably has been missing for years. I don’t even know...
-
GGo back with factory air, 100%
-
GI have an 86 k10 with 700r4. I kept a tvs and went from manifold vacuum to tvs to tcc delay valve to tcc switch. My lock up works...
-
GGander reacted to bucket's post in the thread What size/length/thread pitch bolts for brace on NP208 transfer case? with Like.
M16 would be the bolt size in this case, not the wrench size. Any decent Ace or Do It Best or equivalent hardware store should have the...
-
GGander reacted to Grit dog's post in the thread What size/length/thread pitch bolts for brace on NP208 transfer case? with Like.
Those are beefy bolts and not a lot of shear forces on them for the size imo. I wouldn’t be scared of not using high strength bolts. I...
-
GGander reacted to Doppleganger's post in the thread What size/length/thread pitch bolts for brace on NP208 transfer case? with Like.
I replaced most of my bolts with new - so no doubt I have the (un-needed) originals in a labelled baggie and packed away. I have loads...
-
GGander reacted to Ricko1966's post in the thread What size/length/thread pitch bolts for brace on NP208 transfer case? with Like.
Push comes to shove you can use Allen's. They are usually better than grade 8. Or m10.9
-
GGander reacted to legopnuematic's post in the thread What size/length/thread pitch bolts for brace on NP208 transfer case? with Like.
A 208 should be all metric hardware. You can remove the remaining bolt and nothing should come crashing down. If it does there was...
-
GGander replied to the thread What size/length/thread pitch bolts for brace on NP208 transfer case?.Hardware store and parts houses don’t carry the size. Fastenal/Grainger do but they won’t sell unless it’s a box of 10 and they want...
-
GGander replied to the thread What size/length/thread pitch bolts for brace on NP208 transfer case?.So it was like this when I got the truck. Shot motor mounts and loose trans mount and the PO had been driving it around like that for a...
-
-
GGander reacted to Ricko1966's post in the thread What size/length/thread pitch bolts for brace on NP208 transfer case? with Like.
Pic. So we know for sure what you are after.
-
GGander replied to the thread What size/length/thread pitch bolts for brace on NP208 transfer case?.If so that would be awesome! I’ll cover shipping, message me and I’ll give you my address. That’s exactly what I’m asking for. Anyone...
