Recent content by Donald

  1. Donald

    starter rebuilding - advice needed

    I have been using a starter that the 1997 Tahoe 350 uses on all my Chevy engines with the large flywheel 168 tooth , that most use . They have a reduction gear and are very reasonably on line . Just put one on my GMC works great .
  2. Donald

    Muncie 4 Speed In A Truck?

    Stay away from Muncie's made in 63 they had no bushing under the 1st gear and can seize to the out put shaft under heave loads .
  3. Donald

    Wiring harness options

    I too like American Autowire
  4. Donald

    Header angle / ground clearance

    I used 3/4 length headers gave all the ground clearance you need to keep exhaust inside frame rails .
  5. Donald

    350 to 400 swap... Worth it?

    I will make this short Yes, it is worth it, all the story's about 4oo's overhearing I have never had one overheat as long as you have a decent cooling system not a worn out clogged up mess. In fact, I have one sitting in my garage waiting for something to put it in.
  6. Donald

    Am i calibrating this starter right?

    Knckle Buster hit it on the nose , I always used a paperclip to check my starter gear cleanance .
  7. Donald

    What new tools have you got lately?

    I didn't get new tools but new toolboxes .
  8. Donald

    Rear-end shot

    A shot of my 31 Chevy with a Richmond quick change .
  9. Donald

    Myrtle Beach Run to the Sun Car Show

    Any one wanting to go in 2024 make sure you register on line . If the sell out like this year you will not be able to register at the show . There where people buying window stickers from cars that where registered for as much as $400 . By the way my 1931 Chevrolet Hercules pick up won truck of...
  10. Donald

    Long tube headers/dual exhaust question

    Unless you are out for total performance I think an X or H pipe would be a waste of time.
  11. Donald

    AMD Bumper...anyone purchase

    I don't know if you need the complete bumper , I got the complete bumper kit with all the hardward from USA1 $529.95
  12. Donald

    Anybody recognize these seats?

    Look a little like Ford ranger
  13. Donald

    Bed cover

    Thanks I will give them a call .
  14. Donald

    What did you pay for a square

    I payed $600 for mine 4 years ago .
  15. Donald

    Bed cover

    Does anyone known who makes a hard 1 piece bed cover that will fit a 85 GMC or C10 short bed either inner or outer . None of the venders I have checked don't make them anymore .
See more

Latest posts

Forum statistics

Threads
42,237
Posts
911,903
Members
33,739
Latest member
michaelmarine53
Top