-
-
CI had a socket with a bad ground. The socket itself was bad. I rebuilt the socket with a good ground wire and the problem was solved. I...
-
CFor future troubleshooters, I had the exact problem as OP. I followed the directions on this thread as laid out by chengny, and found...
-
CWhen the heat doesn't work.... A trick you can sometimes do, pull the clip off the brake hose. Pull the brake hose and metal line out...
-
CChevybox reacted to Trucksareforwork's post in the thread Correct timing and which vacuum port with
Like.
What motor do you have? If you have a 305 then 12 BTDC is likely way too much initial timing. You are likely to get pinging. Stock is... -
CChevybox reacted to 80BrownK10's post in the thread What is the best oil to run in 1984 C10 with high-milage stock 305? with Like.
I would use 15w40 but not the synthetic. People use it cause these are flat tappet motors and they need zinc. The EPA requires less zinc...
-
CChevybox reacted to NickTransmissions's post in the thread 454 460 horsepower swap into a 1987 V10 with 700r4 with Like.
If built correctly, the 700R4 can handle big block 454s assuming they aren't putting out more than about 550TQ...I know this for a fact...
-
-
Loading…
-
Loading…