bucket's latest activity
-
bucket reacted to GreenRacer 64's post in the thread 73-87 Rear Disc Brake Conversion Problem with
Like.
The ebrake adjustment has the pads so tight to the rotor that I can barely turn the rotor. I've read that if they aren't tight, the... -
No, I didn’t use sealant. I’ve never seen anyone personally use sealant on freeze plugs so I had no idea. I’ve never had an issue and...
-
bucket reacted to nvrenuf's post in the thread I think a rod spun a bearing in my rebuilt 454 with Like.
That's a Gen V block which was a short run design. I prefer Mark IV stuff because of the massive aftermarket support, probably more than...
-
bucket reacted to Ricko1966's post in the thread I think a rod spun a bearing in my rebuilt 454 with Like.
Forged internals would have done nothing to prevent this. You don't need new pistons,454 Vette rods are Forged,and 99 percent of people...
-
bucket reacted to txaggie's post in the thread I think a rod spun a bearing in my rebuilt 454 with Like.
Yep but who’s to say that thing is built right too. This pricey guy will back his work locally.
-
bucket replied to the thread bulkhead fitting sludge.I've used dielectric grease on trailer plugs for a long time. It's actually very good at fixing poor connections.
-
bucket replied to the thread What have you done to your square lately??.Heating the plastic with a heat gun or torch?
-
That can't be.. that one says its Heavy Duty. ;)
-
Great info, thanks bud.
-
bucket reacted to TotalyHucked's post in the thread What have you done to your square lately?? with Like.
I would highly suggest, beg almost, for you not to clear your truck. Mine is cleared over patina and I wish so much they'd never done...
-
There are so many projects left unfinished because folks wanted them to be perfect. I got over that crap years ago. None of my junk is...
-
bucket replied to the thread bulkhead fitting sludge.The gooey stuff pictured is factory-applied.
