AuroraGirl's latest activity
-
Four seasons says to add the oil to the compressor then stand it on end for 1-3 minutes to lubricate the front seal. I would doubt the... -
https://quadstartuning.com/products/6-5l-alternator-pulley Found this. If you still need one of these
-
@AuroraGirl none of this useful info is probably going to stick in my mind, so I'll probably be asking you the same question in the...
-
May be a bad neutral safety switch
-
Yep. The price of efficiency. The mighty TDI has three glow plug elements in the cooling system to provide defrosting in cold weather...
-
That would explain why I've never seen it before. I've only ran across a couple diesel squares, and honestly didn't pay any attention...
-
AuroraGirl replied to the thread Evaporator Housing Cover Necessary?.yes, hoods would have insulation regardless of being inside or outside opening probably, and regardless of trim The resonance and drone...
-
Exactly. Diesels got a bunch of soundproofing that other engines didn't. I think there was extra jute padding on the inside firewall as...
-
AuroraGirl replied to the thread Evaporator Housing Cover Necessary?.its part of the extra insulation that diesels got
-
Pull off a rear drum and measure the shoe width. It will be either 2.5" or 3.5". Typically the rear drum/shoe size is also used in the...
-
AuroraGirl replied to the thread 1977 C20 Heavy duty with 11.15 drums?.have some new info: there were TWO sizes of 13 inch drums, apparently the backing plates/shoes/drums are different, and the 73-80 and...
-
-
There are many coatings advertised to seal the inside of gas tanks. Any of those would work fine, considering the filler neck only sees...
-
Also finally tracked down the discontinued S shaped oil filler tube that’s needed to clear the dbc throttle body
-
AuroraGirl replied to the thread 81 K10 fuse panel layout.there is not a fuel pressure sensor in a late 90s early 2000s Gen 3 LS If you have throttle cable and EGR, that would be early 2000s...
-
AuroraGirl replied to the thread 81 K10 fuse panel layout.i see a purge valve and what looks like an EGR pipe in that order Im not sure what the last photo with arrows is
