AuroraGirl's latest activity
-
To perform a voltage drop test on the battery cable, you should connect one of the voltmeter’s leads to the starter motor battery... -
Lol, that was hard to read. I just can't figure out what would be different, because they supposedly are. They only thing I can figure...
-
The ICT mounts put the Trans/ Tcase where I wouldn't have to drill anymore holes in frame. It all just worked out better. I measured the...
-
AuroraGirl replied to the thread Best way to transport 19 55 gallon barrels?.Im glad I rememebered to come back and ask this. Is that a lincoln grease gun?
-
AuroraGirl replied to the thread Trailer wiring on a 77 K5? How do I do that?.you mean where the center pin and one of the outer pins seem to trade roles? I feel like I remember coming across that , a lot of the 7...
-
Vacuum brakes suck :laughing1:
-
If its not too late, add (don't disconnect anything) add Heavy duty jumper cables in parralel to positive and ground wire. Try to start...
-
Like Turbo pointed to, a bad connection acts like what we could call a dropping resistor. All the voltage and amperage would be seen...
-
AuroraGirl replied to the thread 8.1 vortec into 1979 k30.on the gmt400 forum this is what a member there said so it sounds like it checks out
-
-
AuroraGirl reacted to bucket's post in the thread 1985 chevy c30 cab and chassis 4x4 swap with
Like.
Not necessarily. I believe 3.73 and 4:10 were still the most common. I believe you could also get C30's with a 3.21 ratio. Of course... -
AuroraGirl reacted to bucket's post in the thread 1985 chevy c30 cab and chassis 4x4 swap with Like.
C6P or not, it doesn't matter. A K20 is going to have different rear perch spacing and different spring hangers, along with different...
-
AuroraGirl replied to the thread 1985 chevy c30 cab and chassis 4x4 swap.but a c6p front axle would have more desireable ratios (that I presumed he wanted) and bigger springs wouldnt it? Thats where I was...
-
AuroraGirl replied to the thread 3 minute battery life…?.you should get something, but youre right in that internally corroded ones will be hidden more so Since the end connections are clean...
-
AuroraGirl replied to the thread Highway vibration 55-65mph.And look at each tire, find out how much weight is put in each spot, tell or show us whats the most amoutn of weight in a spot
-
AuroraGirl replied to the thread Highway vibration 55-65mph.you can find wheel high points and low points and tire high and low with a dial indicator But it does also kinda require having a...
Latest posts
-
-
-
-
-
4l80e conversion in 1985 suburban. What parts do I need?- Latest: NickTransmissions