ali_c20's latest activity
-
ali_c20 reacted to Ricko1966's post in the thread New coil springs too strong? Can't connect upper ball joint with
Like.
Just throw a chain on the ground. Set your floor jack on top of it. Wrap the chain over the frame. The floor jack arm can go up but the... -
ali_c20 reacted to mpigott's post in the thread New coil springs too strong? Can't connect upper ball joint with Haha.
Same happened with my c10. Solve problem by installing an anchor in the concrete under the frame, attached frame to anchor, and jacked...
-
ali_c20 reacted to Bloodhound1981's post in the thread New coil springs too strong? Can't connect upper ball joint with Like.
Definitely can happen with the ones that hook over the coils. This one goes up through the center of the coil and the two steel plates...
-
ali_c20 reacted to mibars's post in the thread New coil springs too strong? Can't connect upper ball joint with Haha.
There is another method:
-
ali_c20 reacted to TX87R10's post in the thread New coil springs too strong? Can't connect upper ball joint with Like.
Desperate times call for desperate measures... Thanks everyone for help and ideas!!!! Got it
-
It’s hard work gathering the parts and building a factory tach cluster, but it’s totally worth it. One tip, an easy way to tell the...
-
Yes ground it to the core support. For our purposes no,I don't think you can have too many grounds.
-
ali_c20 reacted to bucket's post in the thread Tire size or possible lift recommendations for the 79’ K30 with Like.
Those old Selectro hubs (looks like B&M copies?) are pretty cool. Your truck already has a small lift though. So if you are happy with...
-
ali_c20 replied to the thread Hood panel to frame structure foam/adhesive..Wow that stuff is $$$ ~70$ for 200ml/6,76ounces.
-
ali_c20 replied to the thread Hood panel to frame structure foam/adhesive..I used automotive/marine seam sealer/body adhesive on the hood of my C20. It works but I have no clue if it's permanent solution.
-
I'd see if there's any bolt-on replacements for other trucks available at the parts stores (often in the Dorman/Help isle) that have the...
-
You may not get a response the OP hasn't been seen since 2019, so repost an introduction in the intro thread...
-
If you are using let's say a 1979 c10 350,and using the carburetor and brackets for a 1979 engine. I'd buy one for a 1979 c10 Chevrolet...
