Recent content by 86lover
-
8
Looking for a dash pad shipped
hey. looking for a dash pad shipped or i can get it if close by i have an 86 Chevy truck, looking for any dash pad if its gray or back with out cracks i will a little for but if not i am gonna have to take it some where to get it recovered shipped to 03042 nh -
8
Need vac help 86
So this is right -Brake booster goes to the large port on the back of the carburetor (CENTER?) -trans modulator goes to direct vacuum, usually a port on the #8 cylinder runner, behind the carburetor. CAN I USE A RUBBER HOSE?? -PCV goes to the large port on the front of the carburetor...- 86lover
- Post #7
- Forum: Tech Discussion
-
8
Need vac help 86
forgot to tell you i have a 4 barrel edelbrock 600- 86lover
- Post #5
- Forum: Tech Discussion
-
8
Need vac help 86
hey, i have an 86 truck k10 has a 1970 350 small block, i just got a turbo 350 and had it rebuilt and has a b&m shift kit , and i did the intake manifold and i cant figure out where the hell all the vac line run brake booster, distributor, transmission modal line, and if there are any other...- 86lover
- Thread
- Replies: 9
- Forum: Tech Discussion
-
8
Chevy k10 problem
1986 chevy k10 350 small block 4x4, when i put the truck in park it runs great...but when i put the truck in over drive, drive, 2,1 reverse it has a problem and bogs down really bad and is struggling at this time i throw it in park and its fine, this all happened when i was driving with a full...- 86lover
- Thread
- Replies: 2
- Forum: Engine & Performance
