85K304SPD's latest activity
-
85K304SPD reacted to Old Guy Bill's post in the thread New Tires, What should I do for wheels? with
Like.
I just got the Vision brand from Summit. 17x9 at $92 each. I went with a tire slightly taller than 33”. They also offer the Blackrock... -
85K304SPD replied to the thread edelbrock avs2 650.I have to pump mine about 20 times to start it cold. When it is warm, usually have to pump it a couple of times. It's not fuel...
-
Threw a little Sanford & Son style to the truck. Honest opinions welcome.
-
new member here, this is my 86 k5, been sitting for better part of 20 years time to get her back on the road
-
85K304SPD replied to the thread tighter steering.If you think a C20 is hard to turn sharp, you should try a K30 with a Dana 60 front axle... It makes a K20 seem like a sports car. Like...
-
85K304SPD replied to the thread Thermostat.195
-
I am a farm-raised, central Alberta boy who has been a gearhead since I was a kid. I've rebuilt a few old vehicles in the past (one was...
-
Ha, maybe I should have included a photo of the Blazer eh?
-
Hey All, I built a 68 Bronco 8 - 10 years ago but didn't have enough time for it so I ended up selling it 4 years ago. I attached a...
-
85K304SPD replied to the thread Sad Discovery: GM 10 Bolt Fails.What happened?
-
Now THAT is interesting… A 5 lug K10? Could be that the layout artist made a mistake when creating the brochure. .. ?
-
85K304SPD replied to the thread New to Square Body Trucks, not trucks in general.I would make sure it runs good before I did anything to it. Taking it somewhere to fix that sounds expensive, but if that is what you...
-
85K304SPD replied to the thread New to Square Body Trucks, not trucks in general.Welcome. What are you wanting to do with it, work truck, daily driver, show truck? I dont have any experience with fuel injection...
-
85K304SPD reacted to bmruckh23's post in the thread New to Square Body Trucks, not trucks in general with Like.
Hello everyone, my name is Brandon and I recently purchased this 1985 K20 from marketplace, walking into it I knew it needed quite a bit...
-
85K304SPD replied to the thread Top Radiator Clamps.There is a few different sizes of radiators for these squares. Height and width differences. Brackets, shrouds, hoses, hold downs...
