Well I got it to go on my bandaided QuadraJet. New tires on her. I replaced taillight receptacles and took her to be inspected, the day before we moved. I failed for upper ball joint. So I ground off the old rivets and replaced them. SHow up the next morning to get reinspected and she passes. To...
You have a good point. Just cause the vehicle is not desirable to sell whole or parts it can still be stolen. There are some out there that only require it to get to point B. Knowledge of a standard it not needed as long as you get to point B.
I have the SAE and metric for a few years the older ones the had the size painted on but has rubbed off a few of them . But with them being black the good old junk yard paint pen works great. The new ones are engraved and the paint pen works out good there too.
I have some of my projects hot wired so I can drive them. 10ft of wire and alligator clips. FI has many points where to disable them. if your running a carb and mechanical pump. Progression Ignition distributors you can turn off your ignition with your phone. Remote coil? If all else fails...
I am not a big wood worker. I have a table saw, band saw and a router table. I set them up in the horses shower stall it has cross ventilation and easy to clean up. If I don't need one of the three I just do it outside. I don't have much to cleanup that way. In my garage, I do have a little...
Well its back to cutting and grinding things off. Cut the flex hose off and ground off the ends. The hard line twisted so off it came too. But I now have fluid at all four corners!! Now all the work is to make it go.
And then there was one. I replaced the wheel cylinder a little more evolved than I hoped. It setup my next project after brakes will be bearings all the way around and clean out the rear end. Its raining today but I think I can get to the left front and find the fluid issue.
Well now both the front and rear on the passenger side has good brakes. The other side has bad wheel cylinder and no fluid to be found in the front drivers side. I have a new flex line and new caliper. just using that dry fluid.
After reading your post I picked up one myself. The bolt holes line in the bumper, I want to keep the grate and see if everything lines up well. Then I think about a repaint.