J
jbro1988
Latest activity Postings About
-
-
Jjbro1988 replied to the thread 700R4 Lockup Torque converter control issues solved.I found this guy that had restored this harness out of one. It seems to have two vacuum mechanisms on it.
-
-
Jjbro1988 replied to the thread 700R4 Lockup Torque converter control issues solved.Is there two separate vacuums I should be hooking up on the firewall or just that driver side one? I found I have two wires blue/yellow...
-
-
Jjbro1988 replied to the thread 700R4 Lockup Torque converter control issues solved.@Turbo4whl Would it be possible to run a switch just for 4th gear lockup even though I have the 3 wire setup that’s for 3/4 lockup? The...
-
-
Jjbro1988 replied to the thread Oil Pressure Gauge Diagnostics.No but I bought another sender and had the same reading. I sold the motor with the old one unfortunately otherwise I would’ve checked it.
-
JI think I'd try adding a 20ohm resistor in series.
-
Jjbro1988 replied to the thread Oil Pressure Gauge Diagnostics.I’m having a similar issue. I swapped the 305 out on my 84 k5 blazer and at startup I get like 15 psi or so and goes to 0 at idle after...
-
Jjbro1988 replied to the thread 700R4 Lockup Torque converter control issues solved.Sorry to go off an old thread but this relates a lot to what I’m doing. I have a 84 k5 blazer that I just put a 350 in and had my 700r4...
-
-
Loading…
-
Loading…
