E
edgephoto
Latest activity Postings About
-
-
Eedgephoto replied to the thread 87’ Silverado vacuum lines.Is your vacuum label under the hood intact? That shows where everything connects. I have a 1987 V3500 with 7.4L. I can post a photo of...
-
Eedgephoto replied to the thread Pondering Oil Types [and bad government influence on OEM choices].I watched a couple videos of that guy's. Had to fast forward a bit. He blabbers on and takes forever to get to the point. It is good...
-
Eedgephoto replied to the thread Smog removed: how to cap manifolds?.Get a 3/4" pipe cap or remove the tubes from the manifolds and order some brass 1/4" plugs to fill the holes.
-
Eedgephoto replied to the thread Blower Motor Stopped Turning.I would just pull the rubber boot back and leave the motor connected. Turn it on high and measure voltage. This way you are checking it...
-
Eedgephoto replied to the thread Replacing a single frame rail, can it be done?.Interesting that they go that deep for a VIN check. How do they find the frame vin when there is rust? Do they do this if you have a...
-
Eedgephoto replied to the thread Replacing a single frame rail, can it be done?.Here in CT they do VIN verifications. They look at title or registration and compare to windshield VIN and door VIN. I have been in the...
-
Eedgephoto replied to the thread Glass lock strip replacement.I have had hit or miss luck with LMC. I bought fuel tank insulation for the straps on fuel tanks. What a joke. They sent roofing felt. I...
-
Eedgephoto replied to the thread Aftermarket A/C?.They make 12 volt roof mounted unit. They sell them for use on heavy equipment. I would bet you need a pretty stout alternator to run it.
-
Eedgephoto replied to the thread Ball joint.Be careful heating a ball joint. When the grease expands it causes pressure. I watched a moron blow a hole in his foot touching a ball...
-
Eedgephoto replied to the thread Proportioning Valve and Bleeding.If the hoses are more than 5-6 years old you should replace them as a matter of maintenance. Brake fluid should be flushed every two...
-
Eedgephoto replied to the thread Intake manifold and stripped bolt.Subjective, yes. As I said, do what you feel comfortable with. We have given OP some options.
-
Eedgephoto replied to the thread Intake manifold and stripped bolt.Teflon pipe dope stays pliable as does #2 Permatex. @Ricko1966 has maybe a simpler solution but I would not want two different size...
-
Eedgephoto replied to the thread Truck Overheating.195 deg thermostat is fine. Going with a lower temp. to fix a problem is a band-aid. You need to diagnose the underlying condition. As...
-
Eedgephoto replied to the thread Intake manifold and stripped bolt.I would use a Helicoil. They are a permanent repair. Put a dab of Red Loctite on the insert on the outside so it locks to the head. Then...
-
Eedgephoto replied to the thread Replacing K20 fuel tank.I did not have an inner tube available to cut up. Bike tube would work well as it is thin. A car or truck tube would make getting the...
-
-
Loading…
-
Loading…
