bluex
Latest activity Postings About
-
-
I’ll put yours and @Ricko1966 suggestion in my back pocket. Those are great ideas. At this point I’m actively practicing walking past it... -
Fine thread is better than coarse as well but moreso in durability if using the tool repeatedly under a load.
-
bluex replied to the thread Front spring question.This, i have an old piece of shaft that I got from the scrap barrel at work. Drilled it to fit some M12 bolts (that's what we had in...
-
I'd try 2 bolts screwed into a coupling nut. Use them as a wedge to push on the lower ball joint stud leave the ball joint nut on but...
-
^This. The only trucks that are dead nuts level are on coilovers since they have easy, minute adjustability. That's one thing I love...
-
bluex replied to the thread Front spring question.Huck got most of your questions answered it seems. If you pay attention at shows all these trucks lean one way or another. Just try...
-
Got the pucks installed on that side and went to throw in the bolts, found that 6 of the 8 cab mount bolts are too big. WTF o_O Come to...
-
So then I moved onto the bed. This was a tad sketchy, but not too bad. Same thing, the hardware changed here too. So I just set it down...
-
Came up to the shop Sunday afternoon to work on this some more. Decided to knock out the bodylift since it's pretty simple and I only...
-
bluex reacted to TotalyHucked's post in the thread What have you done to your square lately?? with
Wow.
Hit a buzzard doing 45-50mph Sunday on my way up to the shop, shattered the hell out of the windshield. Thankfully it hit dead center... -
bluex replied to the thread Searching for My Dad's 1979 Chevy Suburban.It should be 1"-48 that's what I used.
-
So last night I decided I wanted to do something other than work on the engine, so I started stripping the front end to...
-
bluex replied to the thread Searching for My Dad's 1979 Chevy Suburban.78 an older columns have a splined output an the common "jeep shaft" upgrade won't work on them. I found out the hard way then bought...
-
Last night, I worked on all the little peripheral details. Installed the new knock sensor grommets in the valley plate and installed...
-
Went for a cruise in the country, checked the local stores for die casts. Then stopped by my buddy’s house for a game of pool and some...
-
-
Loading…
-
Loading…
