Mark80K15
Latest activity Postings About
-
-
Mark80K15 reacted to xm20k's post in the thread Can you pls identify this distributor wiring harness? with
Like.
Plug the Distributor wire direct to the cap and toss all that nonsense out whatever it is it's not needed. Based on the fact you have an... -
Mark80K15 replied to the thread Can you pls identify this distributor wiring harness?.Well, I still don't know if my harness is an Electronic Spark Control or a module to operate an idle speed return solenoid. It's been a...
-
Mark80K15 reacted to bucket's post in the thread Can you pls identify this distributor wiring harness? with Like.
Found it. Not egr related. It's to operate an idle speed return solenoid. Craig and Spencer both know what it is, lol...
-
Mark80K15 replied to the thread Can you pls identify this distributor wiring harness?.Ok @bucket , thank you sir. I'll report back on what happens when I remove it.
-
Mark80K15 replied to the thread Can you pls identify this distributor wiring harness?.Hey @bucket thanks for the info. Can you please tell me anything else about the egr speed switch? I don't know anything about it, and...
-
Mark80K15 replied to the thread Can you pls identify this distributor wiring harness?.I looked a little harder and found this discussion, and it might have my answer (my harness is an Electronic Spark Control). But it...
-
Mark80K15 posted the thread Can you pls identify this distributor wiring harness? in Engine & Performance.Hello, 1980 GMC K15 350 4-bbl, aftermarket Sun tach. There is a wiring harness that plugs into the HEI 12V/tach port. Can you please...
-
-
Mark80K15 reacted to Blazerbiker's post in the thread Tightening down front yoke nut stops NP205 from turning with Like.
I probably am, and thanks!
-
Mark80K15 replied to the thread Tightening down front yoke nut stops NP205 from turning.Hey @Blazerbiker , that makes a lot of sense. Thanks for the explanation. If you are who I think you are, ORD rocks! Gonna try out my...
-
Mark80K15 replied to the thread Tightening down front yoke nut stops NP205 from turning.Hi @H2OnSnow , yes, I looked at the service manual. One reason I decided not to seat the seal fully in it's bore is because before I...
-
Mark80K15 replied to the thread Tightening down front yoke nut stops NP205 from turning.Sorry @bucket , I wasn't clear before. When I said everything locked up, I meant only when the front output shaft is engaged (4H and...
-
-
Mark80K15 replied to the thread Tightening down front yoke nut stops NP205 from turning.So when the yoke is tightened on when the seal housing is present, the yoke dust cap contacts the seal enough that it actually stops the...
-
-
Mark80K15 replied to the thread Tightening down front yoke nut stops NP205 from turning.Trying to find the problem, I removed the seal housing from the front output shaft, and put the yoke back on. I wanted to see what would...
-
-
Mark80K15 replied to the thread SM465 shift rail position to install shifter, or top plate.Hey @PrairieDrifter , your comment is regarding the position of the rails when removing/installing the lid, not the position of the...
-
Mark80K15 replied to the thread Tightening down front yoke nut stops NP205 from turning.Hi all, I still need help on this, if anyone has a similar experience.
-
-
Loading…
-
Loading…
