83Burban
Latest activity Postings About
-
-
83Burban reacted to Steelbuddha's post in the thread What did I do wrong? NV4500 Swap Issues with
Like.
Measure everything, take nothing for granted. You'll figure it out. -
83Burban replied to the thread What did I do wrong? NV4500 Swap Issues.Pilot bush went in for sure after being test fit on shaft. Bought red locktight and new torq wrench just for this the job. Also, I did...
-
With a 97 trans an internal slave you need to use the 97 pressure plate too. Looks like you did so I've got to go with something being...
-
83Burban replied to the thread What did I do wrong? NV4500 Swap Issues.I did for sure install the correct pilot bearing. Test fit on the shaft before it went in.
-
Looks like there is no pilot bushing installed in this photo. Be sure to install one if you haven’t already
-
83Burban reacted to Bextreme04's post in the thread What did I do wrong? NV4500 Swap Issues with Like.
The LUK slave cylinder is the right one. LUK made the rebranded AC Delco clutch and slave cylinder parts and they are the exact same...
-
83Burban replied to the thread What did I do wrong? NV4500 Swap Issues.@Bextreme04 Bell housing came out of a 97 K2500 when I bought the original swap. And no I never did take measurements. Couldn't tell...
-
83Burban replied to the thread What did I do wrong? NV4500 Swap Issues.Just got off the phone with O'Reilly's. Flywheel part# NFW1041. Says it's for a 73-80 454. So at least I did that right
-
-
83Burban replied to the thread What did I do wrong? NV4500 Swap Issues.No...pretty positive a mid 70s 454. Or at least the block is. I'll call up to O'Reilly's and see what the flywheel was. Pretty sure I...
-
83Burban replied to the thread What did I do wrong? NV4500 Swap Issues.Its a 454 truck that was previously a TH400. I'll have to check but im pretty sure the flywheel was for a mid 90s 454 truck with a NV4500.
-
83Burban reacted to Rustisbest's post in the thread What did I do wrong? NV4500 Swap Issues with Like.
I dont know if its your issue or not but when I swapped in an internal slave NV4500 to my Tahoe it called for a different flywheel and...
-
Backstory....spent several years now sourcing parts to put a later model NV4500 in my 83' K10 Suburban. Total Frankensteins monster...
-
-
Hoping it's simple. Need to check all of the culprits, neutral safety if it has it, fusible link, connections, grounding, etc.
-
83Burban replied to the thread NV4500 Swap....Turn key, no crank..Just got it to fire on its own. But something is wrong with the clutch. Wont fully engage. Sounds like something is hitting the...
-
83Burban replied to the thread NV4500 Swap....Turn key, no crank..Well....replaced the old fuel pump.....not pulling fuel. I did not remember draining tank. Possible that someone drained for me while...
-
-
Loading…
-
Loading…
