1lejohn's latest activity
-
1lejohn replied to the thread Need AC help!.I would suspect the controller. The switch maybe bad. The only other thing I would guess at is there is a short in the wiring harness... -
Decades of independent testing has shown that long tube headers often produce gains in power, even on bone-stock engines and often in...
-
1lejohn replied to the thread 1987 Blazer Front Suspension Upgrade, Springs, Bushings, Hangers, Steering Box/Shaft.Thanks for your response. I have thought about welding a washer to the damaged mount. I have replaced all the bushings with the ORD...
-
Finished up my LS swap (L76 aluminum block 6.0 with LS3 heads) and got it tuned. My tuner said the open element "cold air" intake I had...
-
1lejohn replied to the thread backfire under wide open throttle.It could be running lean. The added air just makes the problem worse. Does it clear up once more fuel flows into the carb?
-
1lejohn replied to the thread Best place to hook up vacuum gauge on Edelbrock carb (permanent and temporary).I connected my gauge to the vacuum line running to the HVAC controller.
-
Newbie here. I've owned this truck for 32 years, sold it and just bought it back. 454 4 speed granny 3/4 ton
-
SBC timing tabs may be at the 2 o’clock position, or 12 o’clock (the ones I have seen look more like a vertical tube than a tab), and...
-
Use a spring loaded pull type switch hook it to the 1st reverse shift lever at the transmission. Use something flexible like fishing...
-
What shifter do you have?
-
1lejohn replied to the thread Skool me on timing w/o timing tab.You have to be careful where you install the timing tab. I put one on my truck when I rebuilt the top end. I put it on the new timing...
-
1lejohn replied to the thread 1987 Blazer Front Suspension Upgrade, Springs, Bushings, Hangers, Steering Box/Shaft.Nice write up and pics. I need to replace my front springs front hangers. The bolt hole is egg shaped from the previous worn-out...
-
Yes
-
1lejohn replied to the thread Leaf Spring Torque.I had the front leaf spring U-bolts loosen up and the front end would make a horrible popping sound when turning a tight corner at slow...
-
I believe that it is best to replace u-bolts simply because of the stresses they can see upon removal if they have been installed for a...
