Recent content by 16927
-
ok, i'll bite. where is the reverse light switch
The switch is on top of the steering column under the dash. It’s a reall joy to get to held on by two little screws. I’ve found they can be taken apart by bending the tabs and carefully removing the backing plate (careful of the spring) and clean all the old grease out of it and clean up the...- 16927
- Post #4
- Forum: Manual Transmission & Clutch
-
2-piece Long bed driveshaft
received front yoke, thank you so much! mine is “egged” on one side where a u joint cap ground to dust at some time in its life. This one is in great shape and I can use the old one to help align the transmission putting it through the clutch ! Thanks again!! -
2-piece Long bed driveshaft
Yes I need the yoke please pm me and I’ll give you my address for shipping -
2-piece Long bed driveshaft
Still need the yoke that fits the three speed manual transmission if available.... let me know -
2-piece Long bed driveshaft
If the front yoke that fits in the three speed manual transmission is still available I can use that! -
-
Custom deluxe emblem
Looking for decent custom deluxe fender emblems for my 1981 custom deluxe. Thanks -
-
-
Heater control
William fisher 9 north hunsberger lane Souderton pa 18964 Thanks! -
Cleaning domestic coil
Ok so here an update on my coil saga , I tried cleaning it with condenser coil cleaner, did some good but still smelled even after it dried off. So I ended up soaking it in apple cider vinegar...then neutralized in clean water and baking soda. that did the trick seems clean and odor free now. I...- 16927
- Post #50
- Forum: Tech Discussion
-
Heater control
Custodian, my heat lever is broken, maybe I can make one from two? What do you need for it ? -
Heater control
Hey guys, I need a heater control for a 1981 c10 without Ac. If anyone has a spare let me know. thanks -
Catalytic converter
Thanks for the heads up, I’m on the fence about it really I live in Pennsylvania and the truck is in a part of the state that does not require an emissions test. But I’ve been told that they look for the cat during inspection and will fail it if it is not there. But I’m thinking of putting...- 16927
- Post #3
- Forum: Tech Discussion
-
Catalytic converter
So the old catalytic converter is rotted out on my 1981 250 six cylinder truck. Has anyone replaced theirs with an aftermarket one and are they a direct replacement or are there exhaust mods that have to be done? What aftermarket converter did you use?? Thanks- 16927
- Thread
- Replies: 2
- Forum: Tech Discussion
