Search results

  1. S

    Dashpad vs Cab years

    So the dash pads from 73-80 are different than the pads from 81-87. My question is, is the inside of the cab different. My original cab is an '85 and I found a '73 cab in much better shape. Will my 81-87 dashpad fit in this cab? It's a new pad and I'm building for show so I want it to look...
  2. S

    Steering Column Questions

    So my original truck is a 1985 K10. No tilt, no cruise, wiper controls on the dash. I have a column from an '87 which has tilt, cruise and the wipers on the column. There's a couple things I'm not sure of but have an idea and looking for help. This little black wire comes from the column. I...
  3. S

    4L60E/700R4 Linkage Question

    For those who have done the swap, did you use the 700R4 linkage with the 4L60 Module like in the picture below or is there something different I need to do? Thanks in advance.
  4. S

    Tuff Country EZ-ride 6" vs BDS 6" Springs

    Truck will be on 16/35/16.5 Boggers on 16.5x14 Bart Wheels and 8-lug axles. What real differences are there between these two springs? I know BDS has a no BS warranty (I break it, they replace it) but do either of the springs ride better than one another or are they for the most part comparable...
  5. S

    Gear shift lever...1988+

    May seem like a silly question but can some confirm the end of this gear shift lever (where the key is pointing) threads off? I thought '92 C1500 did I just am trying to be certain. It's on there pretty stout and I didn't want to go wrenching on it and then screwing it up. Thanks in advance.
  6. S

    Wiring schematic 1992 Chevy dimmer switch

    Figure it's worth a shot on here. Anyone have or know where to find the wiring schematic for this dimmer switch? I found the one for the corresponding headlight switch but not this dimmer. I presume there's ground, power in, power outs but not sure which ones or whether I'm right. Any help...
  7. S

    5.3 exhaust

    For those who have done the swap, what exhaust systems are you running? I have an '85 K-10 short bed reg cab. I have Speed Engineering headers with the 3" collector that isn't flanged. I want to run duals with either an H or X pipe in a 2.5". What collectors are guys using and what exhausts...
  8. S

    1-ton swap

    Just curious for those of you who have done the 1-ton axle swaps, did you end up having to relocate the spring perches on the axles? Just curious because my 14-bolt FF has narrower perches than the factory setup so it's not a tough one to figure out, just curious about both the front and rear...

Latest posts

Forum statistics

Threads
42,156
Posts
910,226
Members
33,649
Latest member
MikeD
Top