May be beating a dead horse here, but any source for clutch rod inner/outer floor boots?

[pinballlarry1]

After an hour of fruitless searching, I finally decided to ask all you experts if anyone has found the inner and outer clutch linkage boot seals where the rod goes though the floor?? I saw that someone located a similar boot on McMaster Carr, but everywhere else seems to be a dead end over ten years old.

You must be registered for see images attach

Seems like a fairly common, and always need part for a large number of trucks. Of course, mine is busted into 3 pieces and the air gets in.

 

[SS1019]

Looks like Classic Industries has some. Maybe a bit of a universal and seems a bit spendy but it would plug the hole!

You must be registered for see images attach

 

[pinballlarry1]

Yes, $40 is too much for me. I will be trying this one:

You must be registered for see images attach

Hopefully it does the job, it certainly looks pretty close to the original.

 

[pinballlarry1]

The above rubber boot arrived today, it looks nice and will probably work.

You must be registered for see images attach

It looks to be almost identical to the original:

You must be registered for see images attach

It does have the metal base ring molded in. Not sure if I can work on this project before the beast goes into hibernation for the winter. I am still waiting on a new radiator to arrive so I can drive it again before the snow.......

 

[Burkee1483]

The above rubber boot arrived today, it looks nice and will probably work.

You must be registered for see images attach

It looks to be almost identical to the original:

You must be registered for see images attach

It does have the metal base ring molded in. Not sure if I can work on this project before the beast goes into hibernation for the winter. I am still waiting on a new radiator to arrive so I can drive it again before the snow.......

Did it end up working? I have the 3 hole Version from usa1. But I rather go with that style if it worked lol

 

[pinballlarry1]

I have made no progress on the clutch pedal linkage. Hopefully a summer project.