Dave Nelsen here in northern Wyoming. Started working on Chevys in 1966, (1951 216 C.I. in 1952 Chev. car. FAST FORWARD after Nova's, Impalas, etc.

[WyoAk]

1983 K10 SM 465 subject: I have installed a fully dressed Blueprint 350 cruiser engine purchased from Summit Racing. Also required flywheel to accommodate one piece rear main design and starter to accommodate the flywheel. Here is the unknown: BluePrint nor Summit knows of any clutch/dust/inspection cover available. Factory cover does NOT fit one piece rear main and oil pan design. Hours searching. This MUST be a reasonable common swap. Also no answers on supplied/bolted in place Holley mechanical fuel pump as to pump diameter slightly touching the motor mount AND supply line pointing inside the frame rail and not having a return line for dual tanks. I will try factory designed pump. Any advice, VERY APPRECIATED.

 

[Shorty81]

Welcome from Ohio.

 

[Frankenchevy]

You can make your own out of sheet metal or try giving Advanced Adapters a call.

 

[legopnuematic]

Welcome from Missouri.

 

[animal]

 

[Frankenchevy]

I also think that an 87-91 truck with a 465 / sbc would have the dust cover you seek.

 

[Sad Sack]

 

[Mr Clean]