454 Cylinder Heads

[bucket]

Good used heads from a running 454 that had lower end noises. Engine ran smooth and did not smoke. They are the garden variety peanut port heads for MarkIV engines. $100, picked up in Madison County Ohio. I seriously doubt shipping them would be worthwhile.

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

 

[Tank6x2]

Pretty good deal if someone wants em bucket

 

[bucket]

Pretty good deal if someone wants em bucket

Thanks, I thought so too. The goal is a quick sale!

 

[yevgenievich]

Did you replace them with something better?

 

[bucket]

Did you replace them with something better?

Nope. They came off of the engine from my '90 454 SS. I simply installed a genV 454 that I had ready to go, with the matching peanut port heads (although shaved) in place of the 454 with toasted bearings. I figure I'll hang onto the short block to build a stroker engine with aluminum heads, likely Trick Flow stuff. But I don't currently have a use for the heads off of the '90 454.

 

[yevgenievich]

Nope. They came off of the engine from my '90 454 SS. I simply installed a genV 454 that I had ready to go, with the matching peanut port heads (although shaved) in place of the 454 with toasted bearings. I figure I'll hang onto the short block to build a stroker engine with aluminum heads, likely Trick Flow stuff. But I don't currently have a use for the heads off of the '90 454.

Was curious as I am looking for a cheaper decent aluminium head set up to get eventually as replacement for vortec gen 6 heads. But will be a long while before that gets going.

 

[68post]

Peanuts for peanuts !!!
TTT