4wd
-
Front end grinding when hard accelerating
hello i have a 1977 k10 and i had a griding noise and feel when i hard accelerate in 4wd and a squeal when turning in 4wd. Changed the u joints and the squeal is gone but now it grinds in 4wd and 2wd. What could it be wheel bearings to tight or loose? Dana 44 NP203 transfer with a part time kit.- Big red square
- Thread
- 4wd k10 part time kit u joints wheel bearing
- Replies: 12
- Forum: Differential & Driveline
-
Wires coming from transfercase
I'm currently working on my 1981 c10 chevy, and I've found wires coming from my 4wd transfercase. I have no idea where they're from or where do they go or if they're even stock at all. Anyone has had something similar? Images related.- Goulet264
- Thread
- 1981 4wd chevrolet c10 transfercase unknown wires
- Replies: 9
- Forum: Tech Discussion
-
Dana 44 overhaul...2 different spindles?????
So long story short, i tore apart my 1979 k10 dana 44 front axle that was stock as far as i knew. ordered ball joints U joints and bearings. i got my ball joints in, U joints in but ran into an issue with the spindles. My driver and passenger spindles where noticeably different. the new bearings...- devin bianco
- Thread
- 4wd axle axle shafts dana 44 help k10 rotor spindle spindle bearing
- Replies: 2
- Forum: Differential & Driveline
-
Burnouts with a NP203 full time 4wd?
So I have an odd question. I have a '74 K5 Blazer with a big block 454, Muncie SM465 4 speed, a NP203 full time 4wd, full time front hubs, and a GM 14 bolt rear end. The odometer for the truck says 10k, but I've done the math, and I'm pretty sure it has about 310k (rolled over 3 times) Now my...- AyWoSch Motors
- Thread
- 4wd burnouts. full time k5 blazer np203
- Replies: 47
- Forum: Transfer Case
-
M
Transmission and TCase identification (Muncie + NP)
Based on reading online it sounds like this 4-speed with Low gear is a Muncie SM465 and the 4x4 Transfer case is NP205 - any recommendations for bolt pattern identification or otherwise? Where the truck currently sits boxed in can’t easily crawl under, but will move soon. Thanks - barn...- mdesign
- Thread
- 4wd 4x4 identification k10 muncie new process transfer case transmission
- Replies: 3
- Forum: Transmission & Transfer Case
-
Cracked manifold - looking @ headers and exhaust on a budget. Suggestions?
JimmyDale's got a bad exhaust leak - cracked exhaust manifold on the passenger side - tired of breathing fumes and if I hot rod, he backfires sometimes. 350 motor, he's got some duals right now with some small mufflers, decent deep sound cept for the leak, but I'd like deeper and louder. I...- JimmyDale
- Thread
- 4wd exhaust headers
- Replies: 19
- Forum: Engine & Performance
-
8
27 Spline diesel 700r4
ISO: 27 spline 700r4 from a diesel that is 4wd from an 82-83 (my compatibility year) truck... i am from MI but will pay to ship... must be in working order or willing to trade and split the cash.
