Search results

  1. S

    pulling a engine question

    was wondering if was possible to pull the engine and leave the sm465 and transfer case in the truck. then sit a engine back down in the engine bay and get the input shaft back through the bearing and clutch? Looks like it would be really hard to align it. have done this on several autos. thanks...
  2. S

    Best clutch to buy

    Looking for some advice. I need to put a clutch ,pressure plate,throw out in my sons truck. Stock motor ,sm465,208 case. I put a ASM clutch kit from rock auto,6000 miles ago. It has failed already. Gonna replace tomorrow. What has been some of the better clutches you guys have run. Not sure if...
  3. S

    spicer locking hubs

    A got a set of spicer locking hubs that came off of a 77 blazer that had a corporate axle. I am trying to install these on a my 79 k10 with corporate axle. I have no instructions and did not get to see them come off the blazer. I have tried everything I can think of and I just cant get them to...
  4. S

    clutch rod question

    I am ready to put my hole thru the floor pan/firewall. The dimple I have been told to look for is not there. Floors were replaced at some point. Could one of you guys that have mechanical linkage give me some measurements from the kick panel or some other good referance point.Where the clutch...
  5. S

    drive shaft questions

    I am in process of changing from 350/203 and going to run sm465/205. Long wheel base. I am having a hard time finding a drive shaft.Before getting a new one built I will check with you all ,and see what suggestions there was. Thanks in advance, Steve
  6. S

    Blower motor runs only on low

    1979 chevy with air. Changed switch in dash.nothing changed. Took blower motor out hooked direct to battery it runs fast there. Is that round piece a resistor? When i bypassed that and pluged into the wire feeding the motor ,it wont run at all. What am i missing,bad resistor? Bad motor? Bad...
  7. S

    manual conversion need pedals/linkage

    My son who is 16 is restoring a 79 k10. it is automatic and he got a 4sp. I need the mass jacket,pedals and linkage. He is on a budget.we cant find a set anywhere.would any of you have one to sell? thanks a lot.
  8. S

    Power window /lock wiring

    First time here. Me and my son are putting doors from a 86 on his 79 without power. The 86 power doors were already off the truck. The wires were unplugged right out of the rubber boot. I can't find another truck with a harness to rob. Can I just run hot wires from the fuse panel? If so does...

Latest posts

Forum statistics

Threads
42,220
Posts
911,632
Members
33,727
Latest member
Ls85c10man
Top