R
Rick76
Latest activity Postings About
-
-
Rdid you take the wood bed sills out and maybe have them in the wrong order. i thought there were 2 different sizes....maybe I am...
-
RRick76 replied to the thread Stepside bed hits gas tank.There are two different sizes, but the difference is super obvious. I 100% have them in the correct order and the old sill i replaced at...
-
RReplaced the rotten bed boards and front cross sill. But now the bed rests on the gas tank before the sill reaches the frame...
-
RRick76 reacted to Rustisbest's post in the thread What size crush washers for front caliper banjo bolt? with
Like.
Used some on my 79. I had to bend the brake lines some when I installed drop spindles -
RRick76 replied to the thread What size crush washers for front caliper banjo bolt?.When I came back from the parts store, I realized it didn't seal up perfectly without the washer, so I had a little leakage. I wasn't...
-
RRick76 reacted to fast 99's post in the thread What size crush washers for front caliper banjo bolt? with Like.
Best to replace with new but I have reused them provided they go on the same side and not turned over. Of course, clean surfaces. Visual...
-
RRick76 replied to the thread What size crush washers for front caliper banjo bolt?.Okay I yanked one. The system seals back up fine at ambient pressure without the washer, so i was able to take it out to measure and...
-
RDo I really have to order these online? 76 C10 2wd 250. Do folks reuse them? Do you just take them off and visually match to find a...
-
RIs that hole supposed to be empty? 1976 C10, straight 6, 250.
-
-
-
Loading…
-
Loading…
