Search results
-
Z
89 K5 floor pan repair?
Hi guys, back with a few more questions. As I understand i should stop drill the ends of the cracks then weld up the cracks? Would a 10 gauge sheet welded over the area be thick enough to prevent more cracking? These cracks are on the rear outer bucket seat mount. also there is this rubber...- Zelph
- Thread
- Replies: 1
- Forum: Tech Discussion
-
Z
Book or tutorial for 12V DC?
Sorry for the newbie question. All my limited electric experience is with 120 AC. is there a book or a good tutorial that explains how 12 volt dc automotive works? im reading all these threads with electric issues and it would be nice to have a better understanding of what the responses are...- Zelph
- Thread
- Replies: 3
- Forum: Electrical & Audio
-
Z
Seized engine?
Hi guys. After a $1800 tow bill got my truck home I want to start a diagnosis. 1989 K5 with stock 350 TBI /700R4 ( my dad says the engine isn’t original, but a “target replacement”?) Oil is full, coolant level is full. oil and filter changed prior to trip. Driving approximately 65 mph in...- Zelph
- Thread
- Replies: 17
- Forum: Engine & Performance
-
Z
1989 Blazer body side molding door emblem?
Most of my question comes as a result of my not thinking ahead. I tossed the old molding before I realized it would be useful to have until the job is complete. I’m a newbie. I purchased a roll of side molding and new emblems. My question is in regards to how the emblem attaches to the molding... -
Z
HF plastic welding kit
Hi gang, Im looking to repair the “plastic”? Splash shield thing that screws into the bottom rear of the front wheel well. Mine is cracked around the mounting screw. Would the Harbor Freight plastic welding kit work on this? Any other ideas for repair? Thank you -
Z
1989 V1500 Blazer
1989 V1500 Blazer. 350 TBI, 700R4, 10 bolts with 3.73 and a gov bomb out back. I picked it up in July 22. First thing I did was oil and filter change, air filter, brake fluid change, spark plugs, wires and cap, rotor and differentials oil changed. I’ve been lurking the forum since I got it...- Zelph
- Thread
- Replies: 8
- Forum: Introduction
