Search results

  1. MrMarty51

    Any bikers?

    A pic of My other bike. 1974 Triumph T-150 Trident. T-150 is the model number, A triple cylinder 750cc. model number also represents in MPH of the obtainable top end. it is geared a little taller and is capable of around 160, according to the mile posts as they fly by. measured from the second...
  2. MrMarty51

    Any bikers?

    Too bad We aint living closer on the map. I`d be over bugging You every day until I had that in My possession. :Caffeine:
  3. MrMarty51

    Any bikers?

    1957 Harley 125cc Model B Hummer. https://www.harleyhummerclub.org/members/martin-draper/index.html
  4. MrMarty51

    Any bikers?

    It aint fast but it gets Me there. :Caffeine:
  5. MrMarty51

    Hello from Croatia

    Welcome from the hills and prairies of Eastern Montana.
  6. MrMarty51

    New Feller from Ky!

    Welcome from Eastern Montana.
  7. MrMarty51

    Removing PS Pump Pulley

    I bought a cheap puller set from NAPA, it works real good.
  8. MrMarty51

    Noob From Albuquerque NM

    Welcome to GMSB Sid.
  9. MrMarty51

    Gear oil weight options 87 V10? 10 Bolt? Minor whine

    Yeah Joe, I`m not sure about the source of the whine. My 87 V1500 once picked up a whine so I booted Her out the door. :happy175: Just kidding. It did though, from the rear differential, was on the interstate cruising, all was fine. came upon the exit I had to take, let off of the accel pedal...
  10. MrMarty51

    What have you done to your square lately??

    And then postum in here somewhere, please. :Caffeine:
  11. MrMarty51

    Truck makes clicking noise while driving

    About the only way to check U~Joints is to remove the drive shaft and rotate yokes and trunions, remove trunnion caps and inspect the shaft the needle rollers turn on.
  12. MrMarty51

    Truck makes clicking noise while driving

    Bad U~Joint.
  13. MrMarty51

    1983 GMC k3500

    :welcome:
  14. MrMarty51

    Great looking little Volvo

    If a Volvo of that vintage sounds like a rod is knocking, get a timing gear set and change out the cam gear. it was a bakelite gear with an aluminum or steel hub, the bakelite would wobble loose from the hub and make a funny knocking noise. A family here at one time had the Volvo dealership, I...
  15. MrMarty51

    My 1982 Buick Grand National Project basket case

    Nice project. That hammer looks like a good find. :happy175: I would like to find a GN body to fit into it the engine and transmission I have hanging on the stand.
  16. MrMarty51

    To 6.2, or not to 6.2

    One thing that these engines fuel system needs is a constant fuel supply from the lift pump. I got a kit from a supplier that convers the lift pump to a relay system and also has a switch that can be turned on to prime the system. The system that I got supplies 10 psi fuel pressure under a...
  17. MrMarty51

    Possible engine problem

    Fuel filter ?
  18. MrMarty51

    Check these Purpose-Built Off-Road Wheels by Fifteen52 + Video Review from CARiD

    Analog style wheels dont fit My 2000 K3500 single rear wheel. That's sacrilege. :Caffeine::happy175::happy175::happy175:
  19. MrMarty51

    Best Tie Rods Ends & Front Suspension parts?

    The 14 inch pounds mentioned in the above post, that would be the required torque when going over the center of the steering gear, after going over center the torque required to turn the nut will decrease.
  20. MrMarty51

    Best Tie Rods Ends & Front Suspension parts?

    Rock Auto has a pretty good supply of components and a variety of brands. PLUS, they are a sponsor of this forum and they do list a nice discount code every so often, code lasts until they post a new code.
  21. MrMarty51

    Cleaning up my wiring. What does this plug go to?

    YUP, smog pump or A/C compressor.
  22. MrMarty51

    What have you done to your square lately??

    Been thinking radiator and battery. I know that's a big chunk of change. I`m going back to eork tomorrow so time will build on the pay clock then it wont feel like such a burden when I make the purchase. Other wise I`d charge the components then have that bill hanging over My head. :Caffeine...
  23. MrMarty51

    What have you done to your square lately??

    Well that saved You a fair chunk of change.
  24. MrMarty51

    Brake Light/Turn Signal wiring

    YUP, welcome to the GMSB JR.
  25. MrMarty51

    re: hello from South Dakota

    Welcome John. I just want to add, that is not the old 350-V8 diesel from the Oldsmobile days of the past. That is an entirely new design, of the times, it will be the 6.2 liter V-8 diesel. That engine was carried right up through the present day in the Military Hummers. Now known as the 6.5...

Latest posts

Forum statistics

Threads
45,961
Posts
997,031
Members
39,165
Latest member
twitch1989
Top