Search results
-
Rear shock brackets
easier to carefully cut them off as close to the axle tube as possible and then flush the weld off, clean off your new area, reshape and weld again.- Tank6x2
- Post #2
- Forum: Lifted & Off-Road Systems
-
TH 350C Torque Converter
any other identification markings on the TC??- Tank6x2
- Post #2
- Forum: Automatic Transmission
-
208 swap out for 205.
have you tried researching in the search tab for the answer?- Tank6x2
- Post #2
- Forum: Transfer Case
-
My 78 Custom Deluxe gets a new gear ratio
Nice job bubba!- Tank6x2
- Post #2
- Forum: Differential & Driveline
-
Cab rust repair help-- Which panels do i need?
79 converting to 8668- Tank6x2
- Post #11
- Forum: Paint and Body
-
What have you done to your square lately??
Still doing hood mod, starting the other side now -
Cab rust repair help-- Which panels do i need?
They never end, wait till you modify !- Tank6x2
- Post #8
- Forum: Paint and Body
-
-
Cab rust repair help-- Which panels do i need?
It all makes sense when it’s apart- Tank6x2
- Post #5
- Forum: Paint and Body
-
Seat covers, looking for recommendations - later in the thread reports on how my cover is holding up
No I don’t, but I have had one in the past, worked well enough, it’s a wear item, your hopping in and out so take it for what it’s worth that it’s a cover -
inline six compatability
1962-1988 for the GM V6, check out The Novak Guide to the GM TH400 Automatic Transmission online for a little bit of history on your th400- Tank6x2
- Post #2
- Forum: Carb Fuel Systems
-
Rear end shake upon acceleration
Centre shaft support bearing or mud/snow or ice caked on the inside of the rim, beyond that check your universal joints while your there…- Tank6x2
- Post #2
- Forum: Introduction
-
Seat covers, looking for recommendations - later in the thread reports on how my cover is holding up
B078XCVKDK Enter this into Amazon .Com and it’s yours for 40$ -
Decent looking body my brother saw on fb
Just a aftermarket installation I would think- Tank6x2
- Post #2
- Forum: eBay & Craiglist Listings
-
-
-
I’m looking for this Upholstery
http://www.rpmparts.ca/ prices are all Canadian so cheaper 0.70 for every usd 1$ -
Drive shaft help
Figure out your spline tooth count and overall length, Go to the auto wrecker they should be able to hook you up- Tank6x2
- Post #2
- Forum: Introduction
-
-
Cab rust repair help-- Which panels do i need?
Inner outer rockers, inner/ outer cab corners- Tank6x2
- Post #2
- Forum: Paint and Body
-
What have you done to your square lately??
It will be able to accommodate a taller carb setup, but not just yet, I’m 80hours into this mod, had to prep the original structure of the 81-87 hood to be able to accommodate the 67-68 hood shell, it will incorporate the 67-68 rear hood arch support, possibly a portion of the front as well but... -
What have you done to your square lately??
Slowly working the hood mod, It’ll be just a skim of body filler I think… -
What have you done to your square lately??
Slowly welding the hood mod together
