Zelph's latest activity
-
ZI'd have a local builder build it and install it,that way if there's a problem,it's their problem,not your problem. I would not pay...
-
ZZelph reacted to Bloodhound1981's post in the thread Lost Two Gen 3 LS Engines in my 1986 C10 2WD with
Like.
Small block swap it. Sorry, had to. -
ZRecheck all grounds (battery to body, battery to frame, battery to engine and whatever other ground point those models have) and use...
-
ZThat’s a steering box brace, there’s not one on the passenger side.
-
ZZelph replied to the thread Lost Two Gen 3 LS Engines in my 1986 C10 2WD.Where is the 4.8 engine? Can you take the head off?
-
ZZelph reacted to nvrenuf's post in the thread What’s the best way to fix/clean up this wiring problem? with Like.
What are all the extra wires for? If those are all accessories (aka not bypassed factory circuits) then I’d add a secondary fuse/relay...
-
ZYou need to be measuring from frame locators, not the body. Body mounts have a small amount of adjustability designed into them so it is...
-
ZThis will destroy a 700r4. They have a TV cable it is not a kick down cable. It is a throttle valve cable. It controls the line pressure...
-
ZZelph replied to the thread I’m pretty pissed!!.I’m not familiar with the 92+ years so forgive my question. How come the 4” lift kit didn’t come with bushing? I’d expect the lift kit...
-
ZSince there’s no inner u-bolt against the diff, the axle pictured is either a D60 or a Dodge D44 as both of these had studs or bolts on...
-
ZZelph replied to the thread Aftermarket tranny cross member.https://tejassteelworks.com/product/high-clearance-transmission-cross-member-2wd/
-
ZJust run it through the regular hole by the bulkhead.
-
ZZelph reacted to legopnuematic's post in the thread Will a 8.5 Camaro 10 bolt axle fit in a 1981 squarebody? with Like.
A Camaro should be a 5x4.75 bolt pattern, a 2wd 1/2 ton is 5x5 bolt pattern. Meaning you need different wheels for the rear, or change...
