Zelph's latest activity
-
Z1973-1977 or 78 the brake light switch is just for the proportioning valve. My 79 has a switch on the parking brake pedal. My 76 does...
-
ZFront: 18x8 with 245/45 and a 1.5" spacer Rear:18x9.5 275/40 and a 2" spacer Spacers are made by BORA @...
-
ZZelph replied to the thread 14bolt FF size vs 10bolt..
-
ZZelph replied to the thread 14bolt FF size vs 10bolt.For an 8 lug front, the hardest part to source will be the backing plate. No known aftermarket repops at this time. You’ll need a large...
-
ZZelph replied to the thread front wheel barings.What front axle do you have?
-
ZZelph replied to the thread Buying a rebuilt transmission th350.All turbo 350 are 27 spline output. Check how far the output shaft sticks out. 2.5 inches is correct for the 208. The 203 and 205 are...
-
ZZelph replied to the thread 14bolt FF size vs 10bolt.That there is a 208. I wouldn’t buy any u joints on assumptions. Get a set of calipers and measure what you have and buy accordingly...
-
ZZelph replied to the thread 14bolt FF size vs 10bolt.I’m thinking he has a 208. If not, we need to figure out what front axle he has.
-
ZZelph replied to the thread 14bolt FF size vs 10bolt.What side is your front driveshaft on? Or the front axle differential?
-
ZZelph reacted to DoubleDingo's post in the thread Replace front Seal in SM465 with Trans in Truck? with
Like.
I would recommend unbolting the bell housing, bracing the trans and transfer case in place, remove engine, reseal engine, reseal... -
ZZelph replied to the thread 14bolt FF size vs 10bolt.NP 208 transfer case? Weld in new spring perches with the proper pinion angle. Measure and order a new driveshaft from a vendor of your...
-
-
ZNew stuff headbolts and aftermarket, yeah sure torque to yield. I understand how and why. The argument was just mainly u bolts could...
-
ZI reused a set of decent u bolts once, had to swap the axle used the u bolt again, may have slightly over torqued it but barely. Snapped...
-
ZZelph replied to the thread 87 V10 Wiring.Isn’t the single green wire for a tach signal?
-
ZZelph replied to the thread Garage upgrade.I’m I the only one disappointed that the story didn’t end at the wife opening the door?
