xm20k's latest activity
-
Looks like a stout setup. Looks like this one will need at least one 1350 yoke for the rear joint at least. These 1480 U-Joints are a... -
xm20k replied to the thread 305 small block help???.It's called dwell there are a few degrees at the top were the piston does not move but the crank and rod does stopping the piston short...
-
Something seems missing in your picture. Thought it needed a little something extra.;)
-
xm20k replied to the thread How much paint do I need?.I swapped on a new set of front fenders recently I painted them last fall just the 2 front fenders used 4 cans of primer and 6 cans of...
-
xm20k replied to the thread Is this a bullet hole?!?.I don't think a bullet hole a 12ga shotgun is .729 inches in diameter and at the muzzle it's not going to open at all even at 7 yards...
-
xm20k replied to the thread LWB driveshaft question.70" I believe with a TH350 mine is 72.5 due to the powerglide. Mine only came close to the cab floor directly under the seat area but a...
-
-
Thanks for confirming. Looks identical to the one I have. Yeah I knew I had a problem when Mark Williams' told me to pound sand when...
-
xm20k replied to the thread LWB driveshaft question.Mine is an aluminum 5" at 72.5" center to center but that's because no one would build a steel one longer than 60" for over 500HP. Best...
-
-
Nothing left to do but wait for head gaskets.
-
xm20k replied to the thread What have you done to your square lately??.Filled her up cost me almost $100 and drove her to work today. Has a slight hesitation at tip in thinking the K&N air filter in the...
-
-
ARP oil pump stud and oil pump installed. Canton reinforced timing cover on, and cam button end play done (that was a tricky one)...
-
Get some 2.5" drop spindles and go back to stock springs.
-
xm20k replied to the thread Gas tank replacement, 16 gallon.Only ever seen them in bare steel with like an oily greasy coating, Black E coat, or Painted Grey like the ones I pulled out of mine...
-
-
If the driver's side tabs are in fact loose, they are not supposed to be. They were supposed to be spot welded together. Passenger side...
-
xm20k replied to the thread Redundant oil pressure sender?.This, it's just acting as a switch for the choke.
