Recent content by wusaah
-
W
83 corporate 10 bolt rebuild
yes hit is out at the hubs. I was just referencing the whole front. this says it sits between the spindle bearing and seal and the axle shaft u-joint on the outer axle shafts- wusaah
- Post #9
- Forum: Front Diff & Hubs
-
W
83 corporate 10 bolt rebuild
So a while back I got a link to maintenance manuals here on the site. I downloaded the following: Corporate_axle_1977-1983 ST_330_83_1983_Chevrolet_light_duty_truck_10_to_30_service_manual In the corporate axle manual it shows the exploded view of the axle & diff components, and from the...- wusaah
- Post #7
- Forum: Front Diff & Hubs
-
W
83 corporate 10 bolt rebuild
Anyone out there Guys I just need a little advice. Any help??- wusaah
- Post #2
- Forum: Front Diff & Hubs
-
W
83 corporate 10 bolt rebuild
So I have replaced literally EVERYTHING on my front diff. I cannot figure out the oil deflectors and how they are supposed to sit on the axle. They keep coming out and would make a helluva noise if I tried to run them. Any advice? I also cannot figure out the "Spacer, outer shaft bearing part #...- wusaah
- Thread
- Replies: 9
- Forum: Front Diff & Hubs
-
W
New From Virginia - New to me Burb
Hey I'm just "down the road" in Fredericksburg. If you need help or want to talk shop, give me a holler. There is always cold adult beverages in the shop fridge. I am always looking to swap parts or chase down parts if need be. I have a knack for finding needed parts.- wusaah
- Post #18
- Forum: Introduction
-
W
New VA member
Howdy all. I live in Fredericksburg, VA. I am new to the site but not the trucks. I have had my 1983 K10 for about 15 years. I put it out to pasture about 7 years ago due to chasing Harleys and Hot Rods. I have just pulled it up out of the back and started a make over on it. I built a rockin'...- wusaah
- Thread
- Replies: 5
- Forum: Introduction
