So far I've got the motor on a stand and tearing it down to at least do a head gasket and whatever else I find. Just got a box full of parts hoping to get to it after the holiday. If the weather holds I should have the old drivetrain out I'll post when I do.
So finally got the engine and trans out yesterday I'm going to put the motor on a stand and just run through the top end doing inspection and replacing gaskets. This is the first time I've worked on an engine out of a vehicle are there any things i should pay extra attention to?
Hello everyone my name is Greg and I have a 1986 K10 that I've done some modification to. Getting ready to do an LS swap into her to replace the 4.3 v6 and 700r4 to a 5.3 4l60 combo I own the 2001 Yukon donor but it was wrecked when it was stolen. So I've decided to make it live on in my...