My response from another thread: I Also have an 86 K20! I too found it challenging to mount the brackets / tank (new brackets, new tank… both from LMC). I used a large piece of cardboard and some scrap wood under the tank (cardboard for scratching, wood to prevent damage of threaded rod...
I’m not sure what HB means…
Fast99 wrote “…It may have a HB problem due to pulsation but shouldn't cause stalling. Later on, when it runs right flush out the old PS fluid.”
I Also have an 86 K20! I too found it challenging to mount the brackets / tank (new brackets, new tank… both from LMC). I used a large piece of cardboard and some scrap wood under the tank (cardboard for scratching, wood to prevent damage of threaded rod protruding from bottom of lmc straps that...
86 K20 - everything shut off while driving on interstate. Noticed Wire from positive terminal to top of alternator was hot (starting to burn up). There is a quick disconnect on the positive terminal too. I disconnected that wire (from batt to top of alternator) and it was throwing sparks the...
I didn’t this realize this!! Before I found my k20, I passed up on several low mile good condition CUCV’s out of fear / ignorance, that I would have to do some major swaps to not burn anything up.
They are flat and those rear springs are beefier than mine. I suppose a cucv called for that tho? Different topic: How or will u or can u even address the speed limit rating of the cucv (65 or 75 is it)?