texasmike's latest activity
-
A DVM is not a jumper wire. You need a jumper wire to jump the switch. Also check the ground side of the circuit, especially if both... -
texasmike replied to the thread Power door locks.Thanks Glen, I was wondering where the door lock switch was grounded. I guess that bus bar is behind the kick Panel?
-
This will be a dumb question for most of you; If I am getting 12v to my switches and either lock does not operate, if I use my meter...
-
Also... this is NOT a fuse. I have seen these metal auto resetting circuit breakers go bad in such a way that they will show continuity...
-
texasmike replied to the thread Looks like bad news for me.OK, here is the latest. With my digital VM, when I touch the red lead to the org/blk center pin wire on the switch and the blk lead to a...
-
texasmike replied to the thread Looks like bad news for me.Thanks guys, you have not insulted me and I appreciate your time and help. I'll give it another try. BTW, that window/power lock diagram...
-
Power goes in one side of the fuse box,through the fuse,and out of the fuse box to the load. If the fuse is bad power does not go...
-
I think you and your meter may need a little instruction. I hope I am not insulting you, but what you are telling us makes no sense...
-
texasmike replied to the thread Looks like bad news for me.I checked the metal fuse (breaker) for continuity between the two spades. It quickly went to zero.
-
texasmike replied to the thread Looks like bad news for me.Yes, the fuse checks good. Before I put the fuse back in, should I check for continuity from the right pin to the switch? The switch has...
-
After my power door locks finally quit working and taking my door panels off at least four times, I finally discovered that the 30 amp...
-
-
My door locks have been working sporadically for the last 3-4 weeks and then, they completely stopped. I pulled off the drivers side...
-
texasmike reacted to KnockingDiesel's post in the thread New Motor/Pump and Switch windshield washers still not working with
Like.
Thank you, it is a cardone. i will try the ground tomorrow and report back. -
texasmike reacted to 84-C20's post in the thread New Motor/Pump and Switch windshield washers still not working with Like.
Ok, so #1 thing I need to know is what brand of wiper motor did you install and was it a remain. We have had horrible luck with...
