I was told by a buddy that i need to switch to a "solid lifter type" cam to use these is this true and why?
you mean if i use the cam i mentioned? or stock one?
nice! Obviously the head was off right?
As of now the motor is still in the truck, and running. I'm gonna need to pull it later to change the bottom end gaskets and a few other things. my budget is kinda tight so it will be a while before i can actually get some head gaskets to do drill...
ok i have a set of 1.6 CompCams Rollertip Rockers that i got from a friend. I want to install them in my truck but i need some info on installing them.
They are 1.6 Ratio
1: What other parts do I need? eg... guide plates, studs, etc
2: Do I need to machine the heads? eg...
thanks hotrodpc!! i found a Pinion Service Kit which i think has 28 splines for $80 on jegs.com but the pictures don't indicate that there are splines in what i'm getting.
http://www.jegs.com/i/Auburn%20Gear/109/541012/10002/-1?CT=999
you know it really does look the same.
How does it perform?
I don't want a full spool cause this is my DD.
where can i get some 30 spline axles that would fit this unit?
and what has to be changed in order for this to work?
Thanks to ALL for taking the time to research and answer my questions.
don't have a mic but can get one. The truck is just sittin' right now so i might just take the cover off and check it out when i get a chance.
BTW how much fluid should it take for my rear end?
i'm going to assume that my rear end has 28 splines so if this will fit my housing i will need to get some 30 spline axles only difference i see between the 28 and 30 is that the 30 spline are a little bit longer.
not sure about bearing size though weather or not i'd have to install larger...
Ok I have this posi unit that a friend gave me for doing some work for him. It has 30 spline gears in it and 10 bolts that hold the ring gear but not sure if it will fit my rear end which is a 10 bolt . not sure if it is a stock unit or what here are some pictures
yea the driver seat is super adjustable. not so much for the passenger side though. I never have liked bench seats. After I get the brackets installed I'll post up some pictures.
I'm 6'1 and the seats feel really nice. plenty of leg room.