Recent content by Shawn
-
Disabled 4 cylinders on a TBI motor :) MPG Gain???
By a bad intake I mean I had a bent rod and the valve was worn off where the rocker had slipped off to the left. If I just pull both intake and exhaust I could run on 7? What do I need to do with the spark?- Shawn
- Post #17
- Forum: TBI & EFI Conversions
-
What have you done to your square lately??
From my wife the other day: "You look kinda hot all covered with grease in your Carhartts." -
Disabled 4 cylinders on a TBI motor :) MPG Gain???
Anyone tried this with a carbed engine? This would let me drive my truck around for a while. Gotta wait to put in another engine at this point because of a bad intake on #2.- Shawn
- Post #10
- Forum: TBI & EFI Conversions
-
-
What have you done to your square lately??
Nothing until I get a new engine. Getting one without all the emissions crap. Saving. -
1986 305 to 350
I'm good with tossing emissions and keeping carbed. Looking for a crate 350.- Shawn
- Post #3
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
1986 305 to 350
So my 86 C-20's 305 has a bent pushrod and its lifter is falling apart. I want to swap in a 350. From what I can gather, 1986 is the bastard year SBC. Everything says pre-86 and 87-newer. What makes the 86 stand alone? Can I easily swap a pre-86 or post 87 350 into my 86? I'm obviously...- Shawn
- Thread
- Replies: 3
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
What have you done to your square lately??
Well, I had a bend pushrod and the lifter was falling apart. So... Gonna break it to the wife. I need a 350 for my truck. -
What year cluster?
$100 OBO. I am wanting to add a tach to my 86 but thought this might be a better solution. Tach is about that much by itself anyway.- Shawn
- Post #4
- Forum: Tech Discussion
-
What year cluster?
For sale in my neighborhood. Want to know if its good for my '86.- Shawn
- Thread
- Replies: 5
- Forum: Tech Discussion
-
What have you done to your square lately??
That's what I've read. Just wanted to make sure. -
-
What have you done to your square lately??
When I'm adjusting the valves while engine is running, is there a specific sequence I should be doing it in? -
What have you done to your square lately??
Well it's on a 305. I'll run it until it misses and then my wife will have to let me get a crate 350 :) -
What have you done to your square lately??
I'm hoping to adjust my valves on Monday. Hoping I didn't buy a truck with a flat cam lobe.
