-
-
RoryH19 replied to the thread Dash panel.The right side goes around the edge of the dash on the 81+ -
RoryH19 replied to the thread Dash panel.I guess most have ac
-
RoryH19 reacted to Jonathonmb357's post in the thread Hello, I was introduced to this forum by a buddy. with
Like.
Thank you, yea I am. Born and raised in Texas -
RoryH19 replied to the thread Rear diff swap? Ass u me, they fit?.The 12 bolt will bolt up to the 10 bolt truck. No issue. I believe the yoke is also the same size so the driveshaft will bolt up as...
-
RoryH19 replied to the thread Dash panel.Have you tried, usa1industries, lmc, or classic parts? I replaced mine but I have a Silverado with ac
-
RoryH19 replied to the thread Hello, I was introduced to this forum by a buddy..Welcome, I see you are in my part of the world.
-
RoryH19 replied to the thread Bvllsh!t on craigslist..Yep, it's nice and surprised it's still listed. I don't think you could double your money either. Maybe skysurfer knows the right people...
-
RoryH19 reacted to Flatwater's post in the thread Stock rim size for 1978 GMC K15 Stepside with Like.
I have those on my ‘77. A great looking wheel!
-
RoryH19 replied to the thread Blazer/Jimmy- Suburban, back window dust air scoop..My k5 had one too. It didn't stay on after restoring.
-
RoryH19 replied to the thread Bvllsh!t on craigslist..I don't need another square but that is nice. Never had a 4 door. That blue is great. I painted a k20 like that.
-
RoryH19 replied to the thread Recommendations For Original/After Market Parts Companies.Yes, that's the place.
-
RoryH19 replied to the thread Recommendations For Original/After Market Parts Companies.Agree on USA1. They are not cheap and you have to wait but it's worth it. My k5 upholstery, door pulls, door pockets, headliner, etc...
-
RoryH19 replied to the thread Stock rim size for 1978 GMC K15 Stepside.They are my spares, still have all 5.
-
RoryH19 replied to the thread Stock rim size for 1978 GMC K15 Stepside.81+ for sure. Can't remember if they started earlier.
-
-
Loading…
-
Loading…
