Ricko1966's latest activity
-
RRicko1966 replied to the thread Tailgate security solution needed.Really not much custom to make, 1 factory latch,1 premade lock cylinder,all you have to make is one pull rod. One factory latch would be...
-
RRicko1966 replied to the thread Front spring question.Homemade version if you make one. Drill the heads of the bolts with a large bit to make a divot on the heads. to keep from walking off...
-
RRicko1966 reacted to PrairieDrifter's post in the thread 700R4 Transmission Questions/Issues with
Like.
It's actually a big fluid leak lol. If the seal is junk, it'll weep. But if it's not seated right it'll POUR fluid on the ground. Ask me... -
RDon't drive it if it is slipping until you pressure test the transmission to dial in the TV cable. You will burn up a 700R4 in a few...
-
RRicko1966 replied to the thread 700R4 Transmission Questions/Issues.The only symptom would be a small fluid leak.
-
RRicko1966 replied to the thread Front spring question.This is what I was telling you how to make out of 2 bolts and a coupling nut...
-
-
RBru, I hate (really hate) suggesting this, but you may have burned the clutches out of it already with that cable being so loose. Drop...
-
RNobody really makes a good readily available option. I would recommend that you look around and see if you can find a motor rewinder...
-
RRicko1966 reacted to legopnuematic's post in the thread Good Ospho (phosphoric) and epoxy Test with Like.
When I did my frame, I had it media blasted, the chassis black is DTM/DTR, I cleaned and sprayed it, no primer. I believe it will hold...
-
RRicko1966 replied to the thread Good Ospho (phosphoric) and epoxy Test.Some of the paint over rust products use tannic acid as part of the process the tannic acid needs some iron oxide to work( anyway that's...
-
RRicko1966 replied to the thread 700R4 Transmission Questions/Issues.Do you have a correction arm on the carb,and the correct bracket on the manifold?
-
RRicko1966 replied to the thread Front spring question.I'd try 2 bolts screwed into a coupling nut. Use them as a wedge to push on the lower ball joint stud leave the ball joint nut on but...
-
RRicko1966 replied to the thread Front spring question.Or a fat passenger. Everybody leaves that one out.
-
RRicko1966 replied to the thread What new tools have you got lately?.That's for shock absorbers, and in my opinion would be a PITA on a distributor. I put the wrench on as far clockwise as I can,rotate as...
-
RRicko1966 replied to the thread Good Ospho (phosphoric) and epoxy Test.He said spi says not use acid under epoxy,I don't think that's right. I belive SPI only recommends ospho and only when directions for...
-
Latest posts
-
-
-
-
-
4l80e conversion in 1985 suburban. What parts do I need?- Latest: NickTransmissions