Ricko1966's latest activity
-
Rmaybe they are expecting him to meet the higher standard the federal government has, which doesnt say automatically but it would infer...
-
RWhat shifter do you have?
-
RRicko1966 replied to the thread Carb backfire under load.How long did you drive it with the new carbureator,before the problem appeared? Why did you change carbureators to begin with?
-
RRicko1966 reacted to txaggie's post in the thread Twitchy steering with a big travel trailer (rear sway bar help?) with
Like.
Thanks for the response. The empty weight on the trailer at the scales was around 8600. Im assuming that we probably add 1000 pounds... -
RRicko1966 replied to the thread AN fittings need to be drilled?.Yea. Is it smaller than the inside if the factory steel line running from the tank to the front. Stick a drill bit in each to check size.
-
RRicko1966 replied to the thread AN fittings need to be drilled?.Do you need to drill it out? Is the smallest point more narrow that a factory steel line inside diameter.
-
RRicko1966 replied to the thread Twitchy steering with a big travel trailer (rear sway bar help?).If you don't have enough weight in the front of a trailer,it is very twitchy and can be very scary.
-
RBecause they don't say "Hecho en Mexico" on them like the Goodwrench engines did. Iirc, the older Target master engines were made in...
-
RRicko1966 replied to the thread Leaking Metal Fuel Line??.Use steel line,like factory.
-
RRicko1966 replied to the thread TH350 Cooler Lines.Pics
-
RRicko1966 reacted to legopnuematic's post in the thread Homemade and modified tool thread with Like.
Cab lifting beam for use with cherry picker Cardboard laid out to mark mandrel bends to cut them correctly. Also 3d printed mandrel...
-
RRicko1966 replied to the thread Homemade and modified tool thread.Ran across this slick cab lift attachment,to go on a cherry picker on another site. Anybody seen one for lifting the front clip?
-
-
RRicko1966 replied to the thread My new 83 k30.You are talking about cams,head porting,etc,down the road. Porting old,not great iron heads,when there are so much better aluminum heads...
-
RI think @Vbb199 is running a sniper unit on his 502... its a pretty rowdy unit. I think if I was buying new I'd be looking at a MPFI...
-
RRicko1966 reacted to idahovette's post in the thread Ignition control module dwell programming with Like.
Some of these kids......no clue...........lol
