Ricko1966's latest activity
-
R4.56 was the lowest ratio available for an 84 2500 series, even with a 30.5" tire that is about 3500rpm at 65mph. 4.10s with the same...
-
RRicko1966 replied to the thread Good rear gears.People drove these trucks everyday,cross country,just like they came from the factory,sure someone may have ordered it or installed some...
-
RWho told you it was geared too low? If you like how it drives right now, that's all that matters.
-
RI don't see any reason why you can't drive it as long as you want. My c20 has an sbc with a turbo 400 heavy duty trans w/ 4.10 gears and...
-
RStock tires on a C2500 are probably about 30-31” (245/75R16?), and you don’t have overdrive. Figure out your current rear end ratio and...
-
RFigure out what ratio it is now and what your tire size is. That information would give us something to work off of.
-
RRicko1966 replied to the thread 1985 C20: Carb not getting fuel.If it's s qjet with a vent hose to the charcoal cannister.,I pull the vent hose off at the carb,and fill the carb through the air horn...
-
-
RPull the fuel line off the carb and insert into a bottle, crank truck for a few seconds. It should fill the bottle up a fair amount. If...
-
RRicko1966 replied to the thread Leaking Metal Fuel Line??.Pull the rubber hose at each end leave the rubber attached to the suspect line,put a bolt in rubber hose as a stopper squirt everything...
-
RRicko1966 replied to the thread 5.7 Vortec and TBI.There is a rumor that 1996 express vans? Or box trucks? Marine engines We're a bastard child, vortec head, factory tbi injected engine...
-
-
RThe best solution is to just use the chevrolet performance intake manifold... but it isn't cheap...
-
RRicko1966 reacted to bucket's post in the thread Ignition control module dwell programming with
Like.
That ain't necessarily saying anything... I've got tools that are older than me too, lol. -
RRicko1966 reacted to ASPEC's post in the thread Ignition control module dwell programming with Like.
Already read it... :-) it's how we got here. Very familiar with the replacement procedure as well but thank you. My dwell meter is...
-
RRicko1966 reacted to Turbo4whl's post in the thread Long time listener first time caller, or whatever... with Like.
Brake lights feed up and back through the turn signal switch. Could be a bad contact in the switch or the connector. The turn/ hazards...
-
RIts a load proportioning valve. It limits the amount of braking action on the rear brakes when unloaded so that they don't lock up...
