RanchWelder's latest activity
-
RanchWelder posted the thread Disassemble Clean Roller Lifters, for L31 Vortec SBC in Engine & Performance.Cleaning your roller lifters can go a long way to saving money on a rebuilt Roller Engine. First carefully remove the clips with a pick... -
-
RanchWelder replied to the thread What have you done to your square lately??.Skyjacker front springs and ORD bushing/shackle kit going in. New steering box, not reman. Tanks US Gear Missourah! Pics to follow...
-
RanchWelder reacted to TotalyHucked's post in the thread What have you done to your square lately?? with
Like.
Washed it… Packed it… and drove 337mi to Myrtle Beach and met up with some friends for Run to the Sun and C10s After Dark -
RanchWelder reacted to Strick's post in the thread What have you done to your square lately?? with Like.
Putting the 78 K20 together...finally...
-
RanchWelder reacted to ChuckN's post in the thread What have you done to your square lately?? with Like.
The party donut arrived! Finally!
-
RanchWelder reacted to 82sbshortbed's post in the thread What have you done to your square lately?? with Like.
Also my kick down cable looks to have some slack in it. Probably should adjust it back some. Lol
-
RanchWelder reacted to 82sbshortbed's post in the thread What have you done to your square lately?? with Like.
Removed the wire i had on temporarily to keep the throttle cable from slipping off and replaced it with the correct clip. Google said...
-
RanchWelder reacted to Dr_Snooz's post in the thread What have you done to your square lately?? with Like.
Just finished this rascal up last night.
-
I leave my hoses long and attached at the tank with clamps,with a second set of clamps loosely in place I pushup the tank,fish my hoses...
-
RanchWelder replied to the thread Gas tank installation help please.It's tough to drop the tank and fix the lines without help and a way to jack the tank up at the same time.
-
What I ran into [hindsight should have been quite obvious] was the water pump pully had 2 groves the same diameter, crank pully 2 groves...
-
Like I said, just in theory. I guess I should have said that mismatched pulleys shouldn't create a "binding" situation. Overdriven or...
-
Respectfully disagree, had that problem on one of my trucks. Drove me nuts until I figured it out. Water pump pully diameters were not...
-
only thing I could think is that if you used the wrong pulley slot on a ps pump with 2 or 3 grooves, the outer groove is usually for AC...
-
One thing you are missing is the difference in torque multiplication from a quick ratio box to a standard box.The power steering pump...
