Recent content by prestonwood9

  1. P

    Exhaust smoking

    Noticed some intermittent squealing/squeaking over the last couple coming from the engine. Thought it might be a bearing on one of the front pulleys however it sounded very fluid in nature and would have pop/cracks associated with it at times. Was trying to get some video to identify it but was...
  2. P

    Kill Switch - once again

    So I just bought a basic Bosch style 5 pin relay off Amazon. Cut the starter wire under the steering column. Ran the wire coming from the ignition into the 30 pin. The 87a goes to the horn. Instead of working up an additional relay to make it a ground connection I just ran the wire through the...
  3. P

    Kill Switch - once again

    I literally just installed this in my truck. Does exactly what you want. I used 2 relays but after I got it all setup realized I could have just done it much simpler with a single relay. If you still are looking for ideas feel free to send me a direct message. It can actually be super simple. I...
  4. P

    HVAC Controller

    Than you for the info. I pulled mine apart and cleaned it up as well just like the post. Think it made quite a difference. Thank you again.
  5. P

    Blower motor won’t run on high

    Thank you for the info. What does a noise suppressor do? Is it something that is absolutely necessary? Just trying to make the truck as simple as possible. Thank you again.
  6. P

    Blower motor won’t run on high

    Or could it be the high speed relay? Have not tried to replace this yet.
  7. P

    Blower motor won’t run on high

    Hello, my blower motor seems to run correctly on all settings except high. When switched to high it shuts off completely. I have already replaced the selector switch in the dash, the blower motor resister under the hood. Not sure what could be causing the problem still..? The only other item...
  8. P

    HVAC Controller

    I was hoping someone might be able to help me out. Just bought a new HVAC control panel as a few of the mounts were broken. Also, there is also a lot of slop in the slider that selects which mode the HVAC system is in. Wondering if anyone might know what the white part in the second picture is...
  9. P

    Valve stem seals

    Just wondering if anyone has any recommendation on good valve stem seals? I was going to try and replace them as my 350 burns about 1 qt every 800 miles or so. Haven't checked the compression yet but I don't think its the rings. The stock ones look so small and fragile, was hoping to get...
  10. P

    Stuck oil pressure sending unit

    Anyone have any recommendations on how to remove stuck oil sending unit? Put a wrench on it with some hammer taps, but was afraid it was going to snap off the unit from the threaded shaft, which I’m pretty sure would be a royal pain to fix. Has anyone tried heat? Was thinking about putting a...
See more

Latest posts

Forum statistics

Threads
42,107
Posts
909,216
Members
33,593
Latest member
shake1969
Top