Old Guy Bill's latest activity
-
Old Guy Bill reacted to edgephoto's post in the thread Have a great Snap On dealer finally with
Like.
Snap-On hand tools are great. Their air tools, electric tools, and other things are not so great. Snap-On sockets have a thinner wall... -
Just to clarify. A combination valve includes a proportioning valve. Don't know if adding another one to the equation would cause...
-
OK, I did this procedure last night and took it for a test. The rears lock up and the fronts don't, just like before. Any other...
-
Old Guy Bill replied to the thread Rear Brakes Locking Up.There is always some confusion between “Combination” valves and “Proportioning” valves… Get a Wilwood valve similar to this one, make...
-
-
4.10 minimum. The 4L80 sucks so much power up, you need more gear. I had a 3.90 with my 5.3/4L65 and 315/35/20s and it was perfect, the...
-
I’ve done a lot of work on it, but it’s no where near done. I’ve driven it from Houston to P-ville and from here to Dallas and back...
-
Old Guy Bill replied to the thread New to gmsquarebody.Welcome, nice truck!
-
Hi all just coming over and joining up. I was told to come over here by gxpweasel on gmt400 . I have an 84 c10 , it was my dad’s (pops)...
-
You need one of these
-
Old Guy Bill reacted to Snoots's post in the thread 86 C20 - Climate control not changing position - cable or vacuum operated? with Like.
It may be that one of the vacuum pots has gone bad because you said the rod moved easily. I hope this diagram helps.
-
Old Guy Bill reacted to Scott91370's post in the thread Anybody buy from OBStrucksparts.org? with Like.
Not sure I'd trust a business that uses a .org address. Those are indented for non-profit groups not companies. And pretty much anybody...
-
Old Guy Bill replied to the thread LED dash light replacements.I used the 194 replacements offered by LMC. My eyes see a difference in brightness depending on which way they are installed.
-
Taylor beat me to it- and now Derek- Master cylinders are not all the same, some have the large chamber in the front, some rear, some...
-
Old Guy Bill replied to the thread Wobbly power steering pump pulley.All I can tell you is get the proper tool to remove the pulley…. It’s available fairly cheap.
-
-
Old Guy Bill replied to the thread Rust coating for fill neck.Id think you could just replace it for the same cost…
