Old Guy Bill's latest activity
-
Old Guy Bill reacted to Mr Clean's post in the thread What have you done to your square lately?? with
Like.
Got the rear of the Blazer almost welded in. Did get the posts down on the floor where they belong. I'm must have done it correctly... -
Old Guy Bill reacted to dustinova's post in the thread What have you done to your square lately?? with Like.
I picked up an old, well used metal box that I'm going to use as a bed mount toolbox for my stepside. I'm planning on having someone...
-
Old Guy Bill reacted to Redfish's post in the thread What have you done to your square lately?? with Like.
I have had surprisingly good results shopping for bolts/screws/fasteners from Lowe's. There is an Automotive section in the bolting and...
-
Old Guy Bill reacted to JamesSam's post in the thread What have you done to your square lately?? with Like.
Picked up as close to a match as the local hardware store could get. They are not exact lengths and the heads and washers are not...
-
Just got one, it's good till Jan 10th 2025 287179114258620915
-
The rubber lip on the outside of the outside window bottom seal laps over the top edge of the window opening/sheet metal. If that’s what...
-
Old Guy Bill reacted to Ricko1966's post in the thread Update on my Ignition Module failure! with Like.
I don't buy distributors I use genuine GM,AC Delco gold,or NAPA premium modules. I reuse/ rebuild,find new old stock, as much as...
-
That's definitely a '79-up bed because '79 was the first year for gas doors instead of exposed fuel caps. I believe with that filler...
-
Old Guy Bill reacted to Strick's post in the thread What have you done to your square lately?? with Like.
Hope the Good Lord forgives me for skipping church today BUT I got the 87 new hue today with that time.
-
He means one of these, Im using this one so no you cant have mine
-
Old Guy Bill reacted to Ricko1966's post in the thread Stock fuel pump has a vent line. Edelbrock don’t. with Like.
The return on those and the 33041,same filter different size in and out 3/8 vs. 5/16th, they have a restrictor in the return line so too...
-
Old Guy Bill replied to the thread Starter Solenoid.Check the Neutral safety switch, top of the steering column right at the fire wall.
-
Old Guy Bill reacted to Blue Ox's post in the thread Old man constantly asked to drop his truck.Any stock height C10s left in the world?? with Like.
Key term here
-
Old Guy Bill reacted to 75gmck25's post in the thread 1985 305 keeps dying after a few seconds with Like.
Disconnect and plug the fuel line so you have no gas coming into the carburetor. Then start it up and see if it smooths out and runs...
-
Unless your stock stuff has been burnt up or badly damaged, I recommend just tidying it up and staying stock. The GM harness and fuse...
