Recent content by neiltee
-
N
LED exterior light conversion! not going well :(
I had to use the dual filament incandescent bulbs in the front and rear brake light/turn signal to get proper electrical draw. Then everything seemed to work properly.- neiltee
- Post #28
- Forum: Retro-Fit & Aftermarket Accessories
-
N
No Defrost
If you are looking for replacement parts try "Old Air Products" -
N
$40 well spent on OEM buzzer
I haven't seen this on my 1975 Chevy K10. Where is it located?- neiltee
- Post #12
- Forum: Tech Discussion
-
N
Fuel gauge reading past full
If your gas is going from one tank to the other and filling it, it probably means that the tank switching valve is not operating. The fuel return is likely to be going to the tank with the least resistance. That's to say its returning to the path of least resistance. That was the situation in my...- neiltee
- Post #23
- Forum: Gauge, Speedo & Instrumentation
-
N
Color match for blue interior
The SEM # 15331 Wedgewood blue looks very similar to the medium blue that LMC has for carpet for the 1975 Chevy truck -
N
horn question??
Those look like the stock horns I removed from my 1975 K10- neiltee
- Post #16
- Forum: Electrical & Audio
-
N
Hvac blend door question...
I too am repairing the HVAC air diverting 'stuff' but the heater/defroster flap in my system does not return to the fully up position. Is there supposed to be a return spring? I did just replace the actuator with a new one from OLD AIR PRODUCTS.- neiltee
- Post #8
- Forum: Tech Discussion
-
N
Tachometer?
Where did you mount the tachometer?- neiltee
- Post #4
- Forum: Gauge, Speedo & Instrumentation
-
N
1976 Square drivers side A/C Duct
I used the ducting piece available from LMC on my 75 K10. Fit perfectly.
